Specifications
Table Of Contents
- 1
- Applying development of unilateral communication
- Serial port intercommunication agreement
- Summarize
- Control command format of serial
- Set BaudRate
- Get Reader Version
- Set Relay
- Get Relay
- Set Output Power
- Set Frequency
- Read Param
- Set Param
- Read Auto Param
- Set Auto Param
- Select Antenna
- Restore factory settings
- Reboot
- Start/ stop automode
- Clear Memory
- Set Reader Time
- Get Reader Time
- Set Report Filter
- Get Report Filter
- Set Reader Network Address
- Get Reader Network Address
- SetReader MAC
- Get Reader MAC
- Report Now
- Get Tag Info.
- GetReaderID
- Command format of serial read-write tag
- Collection of operation command
- Electronic tag storage area and notes
- SDK software development
- SDK compose
- Design introduction
- Basic constant and figure
- Constant definition
- API function return code
- Data type definition
- Parameter figure in reader
- Function return code
- Control command function
- Connect reader
- Disconnection
- Set baud rate
- Read version
- Set output power
- Set operation frequency
- Read reader basic operation parameter
- Set reader basic operation parameter
- Read reader auto parameter
- Set reader auto parameter
- Select antenna
- Set relay state in reader
- Reboot reader
- Set time
- Get time
- Get record
- Delete all records
- Network command
- Set IP address for reader
- Get IP address in reader
- Set reader MAC address
- Get reader MAC address
- Read write ISO18000-6B function
- Identify tag ID number
- Identify selected tag ID number
- Read data block
- Write data block
- Slow write data block
- Set write protection
- Read write protection
- Read write ISO18000-6C function
- Identify EPC number of ISO18000-6C tag
- Read a block data
- Write a block data
- Set read write protection state
- FCC警告语大于20cm(1)
Serial port intercommunication agreement | VI-88TR development handbook
『F0H 3+M*(L+8) FBH M M*（L+8）CheckSum』
Command format with reader address:
Command code:FBH
Parameter of reader address:address
Command parameter1: 1byte is the condition of selected tag.
00 Equal to
01 Unequal to
02 Greater than
03
Less than
Command paramter2: 1byte is start address of tag data ADDR, value 0～
223.
Command parameter3: 1byte is data MASK. Each bit in the byte is
corresponding to a comparative byte.
0
The byte not for comparison
1
The byte for comparison
Command parameter4: 8bytes is data for comparison.
Command packet: 『40H 0EH FBH address SEL ADDR MASK
DATA CheckSum』
Return data: if success, byte count of return data= number of all listed tags
M(1byte)+ M *data of (tag length L (1byte)*8(ID)).
『F0H 4+M*(L+8) FBH address M M*(L+8) CheckSum』
2.3.1.4 Read Byte Block
090909RevA|Page 39 of 97