Specifications
Table Of Contents
- 1
- Applying development of unilateral communication
- Serial port intercommunication agreement
- Summarize
- Control command format of serial
- Set BaudRate
- Get Reader Version
- Set Relay
- Get Relay
- Set Output Power
- Set Frequency
- Read Param
- Set Param
- Read Auto Param
- Set Auto Param
- Select Antenna
- Restore factory settings
- Reboot
- Start/ stop automode
- Clear Memory
- Set Reader Time
- Get Reader Time
- Set Report Filter
- Get Report Filter
- Set Reader Network Address
- Get Reader Network Address
- SetReader MAC
- Get Reader MAC
- Report Now
- Get Tag Info.
- GetReaderID
- Command format of serial read-write tag
- Collection of operation command
- Electronic tag storage area and notes
- SDK software development
- SDK compose
- Design introduction
- Basic constant and figure
- Constant definition
- API function return code
- Data type definition
- Parameter figure in reader
- Function return code
- Control command function
- Connect reader
- Disconnection
- Set baud rate
- Read version
- Set output power
- Set operation frequency
- Read reader basic operation parameter
- Set reader basic operation parameter
- Read reader auto parameter
- Set reader auto parameter
- Select antenna
- Set relay state in reader
- Reboot reader
- Set time
- Get time
- Get record
- Delete all records
- Network command
- Set IP address for reader
- Get IP address in reader
- Set reader MAC address
- Get reader MAC address
- Read write ISO18000-6B function
- Identify tag ID number
- Identify selected tag ID number
- Read data block
- Write data block
- Slow write data block
- Set write protection
- Read write protection
- Read write ISO18000-6C function
- Identify EPC number of ISO18000-6C tag
- Read a block data
- Write a block data
- Set read write protection state
- FCC警告语大于20cm(1)
Applying development of unilateral communication | VI-88TR development handbook
1 Applying development of
unilateral communication
1.1 Applying development of unilateral
communication
Apply in software development of continuous and trigger working mode,
upper computer only need to receive tag ID numbers sent by reader, no
need to send reader command.
1.2 Wiegand interface agreement
Wiegand interface transmites unilaterally, can send read card numbers to
controller only, but controller can not send signal to reader. Signal
transmitted from wiegand interface as follows:
D0
D1
0 0 0 01
＋5V
0V
0V
＋5V
Pulse Interval
2ms
Pulse Width
400us
Binary
Number
At present, output waveform from Wiegand interface is as follows:
A. 400us in pulse width，2.0ms in pulse interval
B. 100us in pulse width，1.6ms in pulse interval
C. 50us in pulse width，1.0ms in pulse interval
090909RevA|Page 5 of 97