Specifications
Table Of Contents
- 1
- Applying development of unilateral communication
- Serial port intercommunication agreement
- Summarize
- Control command format of serial
- Set BaudRate
- Get Reader Version
- Set Relay
- Get Relay
- Set Output Power
- Set Frequency
- Read Param
- Set Param
- Read Auto Param
- Set Auto Param
- Select Antenna
- Restore factory settings
- Reboot
- Start/ stop automode
- Clear Memory
- Set Reader Time
- Get Reader Time
- Set Report Filter
- Get Report Filter
- Set Reader Network Address
- Get Reader Network Address
- SetReader MAC
- Get Reader MAC
- Report Now
- Get Tag Info.
- GetReaderID
- Command format of serial read-write tag
- Collection of operation command
- Electronic tag storage area and notes
- SDK software development
- SDK compose
- Design introduction
- Basic constant and figure
- Constant definition
- API function return code
- Data type definition
- Parameter figure in reader
- Function return code
- Control command function
- Connect reader
- Disconnection
- Set baud rate
- Read version
- Set output power
- Set operation frequency
- Read reader basic operation parameter
- Set reader basic operation parameter
- Read reader auto parameter
- Set reader auto parameter
- Select antenna
- Set relay state in reader
- Reboot reader
- Set time
- Get time
- Get record
- Delete all records
- Network command
- Set IP address for reader
- Get IP address in reader
- Set reader MAC address
- Get reader MAC address
- Read write ISO18000-6B function
- Identify tag ID number
- Identify selected tag ID number
- Read data block
- Write data block
- Slow write data block
- Set write protection
- Read write protection
- Read write ISO18000-6C function
- Identify EPC number of ISO18000-6C tag
- Read a block data
- Write a block data
- Set read write protection state
- FCC警告语大于20cm(1)
Serial port intercommunication agreement | VI-88TR development handbook
2 02H
To get hard
ware and software version number of
reader
3
03H
To set relay state for reader
4 04H To set transmitting power coefficient for reader
5 05H
To set frequency channel number of transmitting
microwave signal for reader
6 06H
To read operation parameter wr
itten by last
command from reader
7 09H
To set basic operation parameter: baud rate,
transmitting frequency, RF power output and so on
8 0AH
To select which antenna to transmit and receive
signal
9
0EH
To reboot reader
10
10H
Delete all tag records stored in reader
11 11H To set time for reader
12 12H To get time from reader
13 13H To set the auto work parameter in reader
14 14H To read the auto work parameter in reader
15
15H
To set parameter of filter.
16
16H
To get parameter of filter.
17
30H
To set network addess for reader
18
31H
To get network address in reader
19
32H
To set network MAC for reader
20
33H
To get network MAC in reader
21 54H To send all reserved tag information to PC
22 57H Get Tag records stored in reader
2.5 Electronic tag storage area and notes
（1） Memory unit of ISO18000-6C tag is devided into 4 areas:
EPC memory bank: to store EPC number. It can store 96bits EPC
number at most presently. Readable and writable.
TID memory bank: to store ID number set by tag manufacturer. There
are 32bits and 64bits ID presently. Readable but non-writable.
User memory bank: different from various manufacturer. G2 tag from
Impinj has no user memory bank, while NXP with 96bits. Readable and
090909RevA|Page 58 of 97