Specifications
Table Of Contents
- 1
- Applying development of unilateral communication
- Serial port intercommunication agreement
- Summarize
- Control command format of serial
- Set BaudRate
- Get Reader Version
- Set Relay
- Get Relay
- Set Output Power
- Set Frequency
- Read Param
- Set Param
- Read Auto Param
- Set Auto Param
- Select Antenna
- Restore factory settings
- Reboot
- Start/ stop automode
- Clear Memory
- Set Reader Time
- Get Reader Time
- Set Report Filter
- Get Report Filter
- Set Reader Network Address
- Get Reader Network Address
- SetReader MAC
- Get Reader MAC
- Report Now
- Get Tag Info.
- GetReaderID
- Command format of serial read-write tag
- Collection of operation command
- Electronic tag storage area and notes
- SDK software development
- SDK compose
- Design introduction
- Basic constant and figure
- Constant definition
- API function return code
- Data type definition
- Parameter figure in reader
- Function return code
- Control command function
- Connect reader
- Disconnection
- Set baud rate
- Read version
- Set output power
- Set operation frequency
- Read reader basic operation parameter
- Set reader basic operation parameter
- Read reader auto parameter
- Set reader auto parameter
- Select antenna
- Set relay state in reader
- Reboot reader
- Set time
- Get time
- Get record
- Delete all records
- Network command
- Set IP address for reader
- Get IP address in reader
- Set reader MAC address
- Get reader MAC address
- Read write ISO18000-6B function
- Identify tag ID number
- Identify selected tag ID number
- Read data block
- Write data block
- Slow write data block
- Set write protection
- Read write protection
- Read write ISO18000-6C function
- Identify EPC number of ISO18000-6C tag
- Read a block data
- Write a block data
- Set read write protection state
- FCC警告语大于20cm(1)
SDK software development | VI-88R development handbook
Address: RS485 networking address of reader，Address =0 no networking.
Output parameter:
Protected: protection state，0- no protect，1-protected
return: if function return value is OK, it means read success, otherwise
failure reason.
3.2.5 Read write ISO18000-6C function
3.2.5.1 Identify EPC number of ISO18000-6C tag
apiReturn _stdcall EPC1G2_ReadLabelID(HANDLE hScanner, BYTE mem, int
ptr, BYTE len, BYTE *mask, BYTE *IDBuffer, int *nCounter,int Address);
apiReturn _stdcall Net_EPC1G2_ReadLabelID(SOCKET hSocket, BYTE mem,
int ptr, BYTE len, BYTE *mask, BYTE *IDBuffer, int *nCounter);
Function: to read EPC number of all eligible readable tag in antenna
radiation field.
Input parameter:
hSacnner/hSocket: reader communication port handle
mem: select memory bank；
0 Passwrod
1
EPC
2
TID
3
User
ptr: start address of mask(unit:Bit)
090909RevA|Page 92 of 97