User's Manual

ManualsBrandsShenzhen Visionke Electronic Technology ManualsComputers & AccessoriesWI-FI Card

WI-FI Card User Manual

This driver is suitable for: AX200，AX200Pro, WIE9260, WIE8260, WIE7265,

AX200NGW,AX200S

Release Date: May 20, 2020

Driver support: Win10 64 bit

Note: Since this product is a high-performance AC wireless network card, the

minimum requirement is WIN10 64-bit system and does not support 32-bit!

Please select the corresponding driver installation according to your product model

and system

Summary of content (12 pages)

PAGE 1
WI-FI Card User Manual This driver is suitable for: AX200，AX200Pro, WIE9260, WIE8260, WIE7265, AX200NGW,AX200S Release Date: May 20, 2020 Driver support: Win10 64 bit Note: Since this product is a high-performance AC wireless network card, the minimum requirement is WIN10 64-bit system and does not support 32-bit! Please select the corresponding driver installation according to your product model and system
PAGE 2
WI-FI Card User Manual Hardware installation 1 Unscrew the screws of the chassis and push it out to remove the side cover 2 Remove the file corresponding to the PCI-E interface ( supports graphics card installation ) More file removal tutorials
PAGE 3
WI-FI Card User Manual 3 Insert the four-wire connector of the Bluetooth cable into the wireless network card 4 Align the NIC card with the gap between the chassis and the motherboard and insert it to the end 5 Insert the other end of the Bluetooth cable into the 9-pin USB port on the motherboard
PAGE 4
WI-FI Card User Manual 6 Tighten the screws, fix the network card and install the antenna
PAGE 5
WI-FI Card User Manual Driver Installation 1 Check if the device manager detects the card ( My Computer-Right Click-Management-Device Manager ) 2 Run the driver " WIFI_21.0.
PAGE 6
WI-FI Card User Manual 3 Check whether the driver is installed normally ( My Computer-Right Click -Management-Device Manager ) 4 selection signal WIFI password connected to 5 Run " Win10_64 " Bluetooth driver and select " Next "
PAGE 7
WI-FI Card User Manual 6Choose the type " typical " to install next
PAGE 8
WI-FI Card User Manual 7 Check "I accept the terms (A) in the license agreement" as shown in the figure and select the next step 8 complete as shown
PAGE 9
WI-FI Card User Manual 9 Start Menu-Settings-Devices - Add Bluetooth or other devices 10 add a device type, as
PAGE 10
WI-FI Card User Manual 11 selected Bluetooth device connection ( Bluetooth devices need to deploy pairing mode ) 12 The connection is completed as shown
PAGE 11
WI-FI Card User Manual
PAGE 12
WI-FI Card User Manual This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.