Operating Instruction

ManualsBrandsSHENZHEN VST LIGHTING ManualsElectronics2.4 GHz Wireless Remote Control

Product model：TS14

Product name：2.4GHz (2407-2478MHz) wireless remote control

TS14 Operating instruction

Thank you for purchasing our products. In order to use this product safely and conveniently,

please read the instructions carefully before use. Please keep this specification for future

review.

Address：No.17, Century Industrial Zone, Hutian Rd., Pinghu Town, Longgang District,

Shenzhen City, P.R.C.

Telephone：（86）755-28855166 Fax：（86）755-22642779

Shenzhen VST Lighting Co.,Ltd.

Summary of content (6 pages)

PAGE 1
Shenzhen VST Lighting Co.,Ltd. Product model：TS14 Product name：2.4GHz (2407-2478MHz) wireless remote control TS14 Operating instruction Thank you for purchasing our products. In order to use this product safely and conveniently, please read the instructions carefully before use. Please keep this specification for future review. Address：No.17, Century Industrial Zone, Hutian Rd., Pinghu Town, Longgang District, Shenzhen City, P.R.C.
PAGE 2
Website address：Http://www.vstled.com A：Product overview 1. TS14 remote control is a high-performance wireless remote control, using 2.4GHz (2407-2478MHz) high-frequency wireless remote control, with the characteristics of low power consumption, long transmission distance, strong anti-interference ability, high air communication rate. 2. TS14 remote control does not need additional wiring installation, simple and convenient, installation and use safe and stable. 3.
PAGE 3
C：Product installation 1. Embedded installation 2. Surface mounting D：Battery installation and replacement Take out the remote control, rotate according to the logo of the shell and open the shell, remove the CR3032 button battery, and put the new CR3032 button battery into the battery compartment. Pay attention to the positive and negative polarity of the battery, not reverse. Then, cover with the bottom cover.
PAGE 4
E: Operation declaration 1：Diagrammatic sketch operation of TS14 remote control panel Codes switch hole 2：To code The remote control needs to be coded with the LED lamp before use. The method is as follows: install the LED lamp, turn the power on, light the LED lamp, indicating that the LED lamp is working normally, press the code switch with the equipped code needle within 8 seconds, the lamp flashes three times, indicating the success of the code.
PAGE 5
F：Product warranty description 1. Under normal use conditions, the warranty period of the product is 2 years from the factory mark date. During the warranty period, the quality problem detected by the company will be free of charge. 2.
PAGE 6
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.