Technical Specs

ManualsBrandsShenzhen Wanke Electronics ManualsAudio EquipmentBluetooth Headphones

User Documentation

Multifunctional Wireless Stereo Headphone

Button Description:

Button ON/OFF: To run/stop the system. Press the play button three times to turn off

the light. Hang/Make call.

Button M: Function keys switch between M-Mod. If the device is not connected,

long press or double click to switch the Chinese / English voice prompt

Button Volume up+ / Next song

Button Volume down- / Previous song

1. Technical specification

Wireless solution: 5.1(Wireless system compatible with Wireless 2.1/2.0/1.2)

USB Charging: DC 5V

Frequency: 87.5-108MHz

Wireless distance: 10 meters

Frequency response: 50Hz-20KHz

Output power: 35mW

Signal to noise ratio: 88Db

Charging time: 1 hours.

Sensitivity: 90dB/mW

Impedance value: 30 ohm

Drive unit: 40mm

Duration: 6 hours

Renewal time: 40 hours.

Transmission distance: 10 meters

Battery capacity: 250mA

Transmitting frequency: 2402MHz-2480MHz

Support TF card, Wireless, Make call.

Summary of content (3 pages)

PAGE 1
User Documentation Multifunctional Wireless Stereo Headphone Button Description: Button ON/OFF: To run/stop the system. Press the play button three times to turn off the light. Hang/Make call. Button M: Function keys switch between M-Mod. If the device is not connected, long press or double click to switch the Chinese / English voice prompt Button Volume up+ / Next song Button Volume down- / Previous song 1. Technical specification Wireless solution: 5.1(Wireless system compatible with Wireless 2.1/2.0/1.
PAGE 2
. Paring to Mobile phone or other device To use your Wireless Stereo Headphone, first you must pair your Headphone with a phone or a computer. Once your Headphone is paired and will automatically recognized each other whenever they are within range. Paring to a phone and Entertainment:  Turn on your phone and ensure its ‘Wireless’ function is opened. Turn on the Wireless Stereo Headphone to the paring mode.  Search your ‘Wireless devices’ on your phone by following the phone’s instructions.
PAGE 3
§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment § 15.