Quick Start Guide

Travel Pack and Toolkit
Travel Pack (Board) x 1
Travel Pack (Gears) x 1
EPP Board x 1
Power Assembly & Wing Set x 1
PowerFlight Cell x 1
Jet ONE Controller x 1
Controller Charging Cable x 1
Fast Charger x 1
M6*24 Board Fixing Bolt x 2
M6*15 Board Fixing Bolt x 2
Mast Fixing Bolt x 2
4mm Hexagon Wrench x 1
1. Integrated Port 2. Bolt Fixing Hole
3. Main Wing 4. Mast Head 5. Support Rod 6.
Propeller Guard 7. Tail Wing
4
7
5
6
1
2
3
3. To prepare to pair, short press once and long press
the Bluetooth button on the PowerFlight Cell for 2
seconds. After the PowerFlight Cell is powered on,
nish Bluetooth pairing in one minute, otherwise the
PowerFlight Cell should be rebooted.
4. For Bluetooth pairing, simultaneously press and
hold the Power Button of the Jet ONE Controller and
speed gear “-” button. When the Bluetooth icon
disappears, it means the pairing is successful. If the
devices have been paired before, they will connect
auomatically and Step 3&4 can be skipped.
1. Press the Power Button on the Jet ONE Controller for
5 seconds. Power on the Jet ONE Controller.
2. Short press once and long press and hold the Power
Button on the PowerFlight Cell. Power on the Power-
Flight Cell.
1. Face the battery compartment upward and reset
both Rotary Locks.
2. Insert the PowerFlight Cell into the battery compart-
ment. Turn both Rotary Locks 180-degree to securely
lock the battery in place.
4. Connecting the Jet ONE Controller
Assembly Steps
1. Turn the EPP Board over to insert the Mast & Power
Assembly vertically into the board installation port.
2. After inserting the mast head into the hub to make
sure it ts, x with L-shaped bolts and tighten.
1. Assembling the Mast
1. Attach the Tail Wing on the tail-end mounting hub
and tighten the two M6*15 bolts clockwise with the
4mm Hexagon Wrench.
2. Assembling the Wings
3. Installing the PowerFlight Cell
2. Put the Main Wing on the front-end mounting hub
and tighten the two M6*24 bolts clockwise with the
4mm Hexagon Wrench.
3. Flip over the EPP Board and proceed to the
next step.
Waydoo Flyer ONE Quick Start Guide Waydoo Flyer ONE Quick Start Guide
ENEN
7 8
All rights reserved by WaydooAll rights reserved by Waydoo
1. Side Handle
2. Rotary Lock
3. PowerFlight Cell
EPP Board
The EPP Board acts as the main body and core of the
efoil, with a large area of soft cushion that makes for a
better user experience. High quality composite materi-
als and aluminum alloy are used to reinforce the
board, while the streamlined design optimizes the
overall performance of the product.
1
2
3
Power Assembly & Wing Set
The Power Assembly & Wing Set has a built-in control
system, and uses the EPP Board to complete the
system connection. The ESC and motor are located
underwater and boost eective heat dissipation. With
an overall structure that is easy to assemble and
disassemble, the Power Assembly & Wing Set is quick
to start using.
3. When the indictor light on the Fast Charger changes
from ashing green to full green it means that the
PowerFlight Cell is fully charged. The PowerFlight Cell
usually takes 2 hours to charge. When the red light
ashes on the Fast Charger, it means the device is
malfunctioning. Stop charging immediately if this
occurs.