Operating Instructions

ManualsBrandsShenzhen Wenhui Technology Development ManualsElectronicsWireless control

Operating Instructions for 220V Single Controller

Product parameters

1, working voltage: AC220V

2, working frequency: 433.92 MHZ

3, static current: 8.5 mA

4, load power: 1000W

5, receiving sensitivity: -108 dBM

6, working style: self-locking

7, encoding method: 1527 learning code

8, modulation method: ASK

9, operating temperature: -10 °C ~ +70 °C

10, foot inch: 72 * 38 * 26(mm)

Description of the controller product

1. The wireless controller is equipped with a wireless switch or remote

control using a 1527 learning setting. The free pairing combination

realizes one control(1 switch control 1 light) and two pairs of one(2

switches control 1 light). N to N(multiple switches control multiple

lights).

2. The controller's wiring is as shown in Figure 1: INPUT power input,

OUTPUT power output(LED feed end)

III. Controller operation instructions(as shown in Figure 2)

Clear and pair code

Summary of content (4 pages)

PAGE 1
Operating Instructions for 220V Single Controller Product parameters 1, working voltage: AC220V 2, working frequency: 433.92 MHZ 3, static current: 8.5 mA 4, load power: 1000W 5, receiving sensitivity: -108 dBM 6, working style: self-locking 7, encoding method: 1527 learning code 8, modulation method: ASK 9, operating temperature: -10 °C ~ +70 °C 10, foot inch: 72 * 38 * 26(mm) Description of the controller product 1.
PAGE 2
For code function: Long press the code key for 3 seconds, LED indicator light with flicker 1 time, wait for LED indicator light to press the remote control button that needs to be code, control board LED indicator light continuous flicker 3 times code success. Clear code function: Long press code button 8 seconds, LED indicator light with flashing, then clear code completion, clear all previously learned remote control key code Fourth, the use of switch instructions: 1.
PAGE 3
. When using wireless electronic products, care should be taken to avoid metal masks, large electronic equipment, electromagnetic fields, etc., which have strong sources of interference, so as to prevent the remote control from being short or unable to work properly.
PAGE 4
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.