EC2 DASH CAM CAR DIGITAL VIDEO RECORDER User’s Manual
1. Operation Conditions • Read the terms of the warranty service. • Do not insert or remove a memory card while the DVR is turned on. It may cause damage to the device, memory card and recorded video files. • Use only high-quality microSD cards of at least class 10 providing for the UHS-I protocol to avoid recording failures and playback delays. • It is recommended to use 8 GB to 64 GB memory cards. • The device should only be used with the accessories supplied.
• Do not manipulate the device while driving to be sure you are driving safe. Please, observe the local law. • Set the correct date and time before using the device. • Heating of the case during operation is normal. • Handle the device with due care; avoid dropping/crushing the device. The manufacturer reserves the right to change the equipment list, hardware and software of the device without prior notice. It is assumed that you agree with the provisions above before you start using the system.
1. Specifications: • Video resolution: FHD 1080P • Screen size: 2 inches • Built-in battery • Video recording format: MP4 • Built-in microphone / speaker • G-sensor • Parking mode • Loop recording: 1/3/5 min • Continuous recording • Auto Power On • Date / time stamp • 8GB to 128GB MicroSD (Class 10) • Storage temperature: -20˚ to + 70˚ • Operating temperature: -10˚ to + 60˚ • Input voltage: 5VDC, 1.
2. Equipment: • Car digital video recorder (DVR) • Magnet holder • Car charger • User manual • Trim removal tool 3. Description of the device and its buttons Button description Button Description ON / OFF Press to turn the device on. Press and hold to turn the device off. When the device is on, press to turn the backlight off. Menu In standby mode (no recording), press to enter/ exit the Menu. Press and hold to switch between VIDEO-PHOTO-PLAYBACK.
Rec Press to start/stop recording. When in the menu, use to confirm the selected menu item. UP Press to move up the menu. In the VIDEO and PHOTO mode, press and hold to zoom in; in Playback mode, use to select a file. DOWN Press to move down the menu. In the VIDEO and PHOTO mode, press and hold to delete the image (if you used zoom + before); in the Playback mode, press to select a file. RESET Press to reboot, if no other button responds. 4.
Power connection To power the device and charge the battery, use only the power adapter included. Connect the power cable to the mount or DVR, then plug the charger plug into the car’s cigarette lighter/socket. When the car engine starts, the device turns on automatically. 5. Device operation Device preparation A. Insert the microSD card into the memory card slot. Before installing a memory card, turn off the device; insert the memory card until it is locked.
Turning the device on/off. When the car engine starts, the device turns on automatically. To turn the device on manually, press the power button. To turn the device offand hold the power button for 3 seconds. Loop recording 1) Insert the microSD card into the memory card slot; the Loop Recording mode turns on automatically. 2) 2) It is recommended to set a 3-minute cycle (Settings).
- Using the Up / Down buttons, select the file you need to view and click the Confirm button to start playback. Deletion - Press the M button to enter the sub-menu. - Use the UP / DOWN buttons to select Delete and press the OK button. ATTENTION! Locked files can only be deleted when unlocked; to unlock them, use the Lock item of the submenu in the Playback mode. Another way to delete locked files is to format the memory card. Note. Deleted fi les cannot be restored.
2) Format the memory card and transfer the extracted file to the microSD memory card. 3) Insert the memory card with the downloaded file into the DVR slot. 4) Connect the device to a power source and turn it on. 5) The indicator light will flash while the firmware file is being downloaded to the device. 6) Upon completion of the process, the device will reboot automatically. 7) Check in the settings menu if the correct firmware version is displayed. 8) Format the memory card with the DVR menu.
FCC Warnning: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.