Operating Instructions

The XG-H102 operating instructions

Description of the face

Key definition description

1. ON key: press for 3 seconds, press to end the movement; 4 minutes without movement,

automatically shut down

2. DIS./TIME key: Press to set the target distance, and then press to switch

to select the target TIME;

3. UP KEY: setting；enactment TIME/ COUNT/DISTANCE/CALORIES/PULSETarget value of;

4. MOED key:, motion mode switch

5. STARTKey: Start your movement;

6: SET key: Set the motion mode

Data display range:

TIME Display range 000:00 ~ 999:59; set range 1:00 ~ 999:00 minutes

METER Display range 0 ~ 99999; set range 1 ~ 99999

DISTANCE Display range 0 ~99999; set range 0.1 ~ 99999m

WATTS Display has a range of 0 ~ 9999

CALORIES Showing a range of 0~9999

RPM Displays the frequency of the current strokes, showing the range 1-99

operationdeclaration:

PAGE 1
The XG-H102 operating instructions Description of the face Key definition description 1. ON key: press for 3 seconds, press to end the movement; 4 minutes without movement, automatically shut down 2. DIS./TIME key: Press to set the target distance, and then press to switch to select the target TIME; 3. UP KEY: setting；enactment TIME/ COUNT/DISTANCE/CALORIES/PULSETarget value of; 4. MOED key:, motion mode switch 5.
PAGE 2
1. Install the battery, press ON key for 3 seconds (Figure 2), then press START, and the electronic meter starts to record the motion data. If no data is detected, the data display window is always 0. When a signal input is detected, the TIME / COUNT / DISTANCE / CALORIES window value will count up; 图2 1.
PAGE 3
图5 1.4 When there is no power operation, or when there is no RPM signal input detected, enter the sleep 4 minutes later, and the electronic watch is not displayed; Note: When the battery is low, the display will not appear clearly, Bluetooth will be easily disconnected or searched, Please replace the battery right now.
PAGE 4
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with limits are designed to provide reasonable protection against harmful interference in a residential installation.