User's Manual

8 / 16
2.3 Motion Sensor
Configure
On the Security Panel:
A. Go to Menu---Accessories---Enter User Code (Default: 1234).
B. Press Sensor---“+” ----Motion, then set the Mode, Delay, and Advanced settings.
C. Press “+ Pair”, then trigger the Motion sensor (Just wave your hands until the light is on).
D. Paired successfully, rename the sensors on the APP.
Installation
A. The recommended installation height is 79”-87” (2.0~2.2m) above the ground.
B. Install it in a corner or on a flat wall, with no obstacles or blind spots.
C. It should not be directly facing the cold and hot vents or cold and hot sources.
D. To avoid false alarms, make sure your pets can’t get close to it.