User's Manual

6 / 16
2.2 Entry Sensor
Configure
On the Security Panel:
A. Go to Menu---Accessories---Enter User Code (Default: 1234).
B. Press Sensor---“+” ----Entry, then set the Mode, Delay, and Advanced settings.
C. Press “+ Pair”, then trigger the Entry sensor (Just separate the two parts).
D. Paired successfully, rename the sensors on the APP.
Installation
The entry sensor should be installed on the door or window (see image).
A. First, wipe the area on the door or window clean and apply double-sided tape to the bottom.
B. The door sensor transmitter (large) and the door sensor magnet (small) should be installed
separately. The triangle marks on the transmitter and the magnet should be facing each other, and
the distance between the two is less than 0.6”.
C. When the door or window is opened after installation, the indicator light will be on for 2 seconds to
indicate that the installation is complete.