User's Manual

ManualsBrandsShenzhen Yifang Digital Technology ManualsElectronicsSmart Wristband

Packing contents

1. Pedometer 2. AC-DC Power adapter 3. Charging box

2. Wrist strap (Silicon gel)

Product Overview

Pedometer

1. Ornamental lens –covers

four LED indicators.

2. Contact points for charging

Note: There is one motor

enclosed in the device.

Charging box

3. Micro USB port

4. Contact points for charging

Wrist strap (Silicon Gel)

5. Fixing buckle

6. Slot for holding the unit

7. Positioning holes

Summary of content (4 pages)

PAGE 1
Packing contents 1. 2. Pedometer 2. AC-DC Power adapter Wrist strap (Silicon gel) 3. Charging box Product Overview Pedometer 1. Ornamental lens –covers four LED indicators. 2. Contact points for charging Note: There is one enclosed in the device. motor Charging box 3. Micro USB port 4. Contact points for charging Wrist strap (Silicon Gel) 5. Fixing buckle 6. Slot for holding the unit 7.
PAGE 2
LED Indication There are four white LED indicators inside the device indicating the battery level and amount of exercise, accompanied with motor vibration: 1) Indicating Battery Level During charging: When the battery level is less than 25 per cent, the 4 LED will light one by one repeatedly; When the battery level is between 25-50 percent, LED 1 will keep lighting, with the other 3 lighting one by one repeatedly; When the battery level is between 50-75 percent, LED 1 and LED 2 will keep lighting, with othe
PAGE 3
Motor Response 1) 2) Target reached: If the preset target amount of exercise has been reached, the motor will vibrate briefly 3 times, indicating that user should stop after 3 cycles, with the 4 LEDs keep lighting for 10 seconds. Battery level too low: once the battery level is too low, the motor will keep vibrating for 2-3 seconds, and the device will shut down automatically. About the Sensitivity and Reliability 1. High Sensitivity- Suitable for vigorous exercises or sports; 2.
PAGE 4
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.