Table of Contents 1.Introduction........................................................................................................1 1.1 Product Descriptions....................................................................................1 1.2 Main Functions............................................................................................ 1 . 2.Package Contents................................................................................................2 3.Installation Procedure........
1. Introduction 1.1 Product Descriptions Thank you for choosing WT002 Motorcycle Bluetooth Communication System.The WT002 is a Bluetooth Headset designed for the motorcycle rider and passenger who wish to have clear and reliable wireless communications while riding. This headset is compatible with Bluetooth cellular phones and can be suited to any sort of helmet for motorcyclists.
2.Package Contents 3.Installation Procedure 3.1 Installation method with plastic clamp ①Loosen the screws on the back of clamp with the provided screw driver. ②Open the lining of helmet,insert the clamp in the proper position on the left of helmet and fasten the screw(overly fastened screw can damage the clamp) ③Slide the receiver down into the slots on the headset clamp mount.Make sure that it is locked in securely.
3.2 Installation method with velcro clamp You can directly use the Velcro to mount the interphone on the edge of helmet. See the following pictures. ①Tear off the white paper on velcro and stick the velcro onto clamp&helmet ②Stick the clamp with velcro onto helmet ③Slide the receiver down into the slots on the headset clamp mount.Make sure that it is locked in securely.
4.
5.Functions and operation of buttons 5.1 Turning the unit on into standby mode Press and hold the power/intercom button at the end of the unit. After 3 seconds you will hear a “Di” and the blue LED will begin to flash. Let go of the button and the unit is now in standby mode. 5.2 Turning off the unit Press the power /intercom button for 5 seconds or until you hear 2 “Di” tones and the lights extinguish. Note: When turn off the unit, please don't loosen the power /intercom button when hear "dudu" tone.
Note: Depending on the phone some or all of these functions may not work, or operate differently. 5.6 To Reset the pairing memory →If you have problems pairing, then it is best to reset the pairing memory ①Turn on the relevant unit into standby mode. Press the power/intercom button for 3-5 seconds till a “dudu” can be heard. ②Let go of the button when the tone is heard.(The unit will turn off) ③Restart, the memory will be erased. (Pair again) 5.
③If this fails retry it ensuring both red/blue light sequences are initiated simultaneously and are close together. Also ensure any other Bluetooth devices are turned off. ④When paired, you do not need to go into pairing mode again. In future you only need to go into standby mode (blue light flashing) on both units and press the button on one of the devices.
8.Indication of battery,the AC&USB charger Before using this device, Please charge the headset with provided charger. Please ensure that the battery is fully recharged when you first time use it. We have provided you with the ability to charge the system via the USB port of your computer or if you are away on a trip, you can use the supplied Multi-voltage USB power adapter.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
