Quick Installation Guide Wireless Repeater MODEL: DA213WUS 1. Package content WiFi Repeater x 1 Ethernet cable x 1 Quick Installation Guide x 1 2. Parts of WiFi Repeater 3 1 2 1.Power/WPS/WiFi LED 3.10/100Mbps RJ45 LAN Port 2.
3. LED Indicators/Button/Port Description LED Indicator Status Power Solid on Off WPS Description The repeater connected to a power source properly. The repeater is not powered on. Solid on A WPS connection has been established. Blinking A WPS connection is being established. Off Signal Green The WPS connection is not activated. The repeater has connected to your existing WiFi router on proper position, it will blink if there is any data transmission.
4) 5) Figure 1 Figure 2 Choose the mode you want. (We describe repeater mode in details here. About AP mode, you only need connect router LAN port with repeater RJ45 port by network cable, configure SSID & Password step by step). Repeater will scan neighbor WiFi automatically, after scanning finished, select your WiFi router SSID from pull-down list, enter your WiFi router password, click “next”. 6) Figure 1 Figure 2 Figure 3 The repeater SSID will change to your router’s SSID with suffix_2.
7) Please set repeater login password once repeater SSID & WiFi password configuration finished. It will be same as WiFi password if you don’t change. Then click “Configuration completed”. An information page will be appeared to show your current configuration. 8) Re-connect repeater with configured SSID and password and enjoy internet service now. Please make sure all your configuration is correct, you will need enter login password after 1st time quick installation.
Don’t put repeater near to Microwave oven, refrigerator and Bluetooth device as such devices are not good for WiFi signal transmission. Method 2: Extending your WiFi network by using WPS You can use Method 2 if your router has WPS button, otherwise please use Method iii. 1. 1) Plug the repeater into a power outlet near your existing router (not too far away from your router) and wait repeater to start up. 2) Press your router WPS button, then press repeater button within 2 minutes.
Q4: What should I do if the repeater couldn’t find my router WiFi SSID? Ensure your router WiFi SSID is enabled and can be detected by other WiFi devices (means your router SSID isn’t hidden). Change your router WiFi channel and try again. Change router encryption way to WPA-PSK or WPA2-PSK and try again. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
