User's Manual

Table Of Contents

When half-pressing the shutter button of the

camera, the hot-shoe flash on the receiver will be

awakened. (for A/B type camera only)

Under any connection type, [Test] button can be

pressed to awaken and test the flash on the transceiver

and other transceivers at the same channel.

Test flash with the mode set by the flash, and under

the mode of E-TTL it may fire in a lower output.

Refer to the following figure, the transmitter sets A

+B two groups of flash test, hold down the[Test] button,

the flash on A and B of the receiver will be awakened,

and when loosening [Test] button will fire a test flash.

Flash Awaking and Testing Flash

※ If the flash can not be awakened, manually

awaken the flash before shooting.

※ Using PC port to connect with flash without the

awakening function.

※ All the indicators going out when flash fires.