Users Manual

01 02
Best wear the wristband behind malleolus
ulnaris;
Adjust the size suitable for the size of
wrists via Adjustment Hole; Fasten wrist
strap buttons;
Sensor shall be close to skin avoiding
moving.
1.
2.
3.
When the device starts up, to touch function keys for a short time period can lighten
screen or switch over display;
The screen shall be turned off without operation and users can connect the mobile
1.
2.
phone APP to revise off-screen time;
Switch to the heart rate and blood pressure interfaces to be tested automatically and
leave the heart rate and blood pressure interfaces to stop tests.
3.
POWER ON/OFF
1.In the state of the wristband shutdown, the long touch function key over 3 seconds
can make the device vibrate.
2.When the wristband is in the boot state, it will switch to the shutdown interface. If the
touch function key is more than 3 seconds, it can enter the shutdown interface. After
the short touch is selected Off, it will touch the shutdown again.
OPERATION
WEARING METHOD
Malleolus ulnaris
PREPARATION
Make sure that the power is sufficient before turning on，
Use USB charging port to charge
First remove the wrist
band
Take out the fuselage
Plug into the USB
charging head to charge
For the first time, please take out the
bracelet and charge the device with the
corresponding charger. When charging, the
bracelet will start up automatically (charging
mode is shown in the figure below: remove
the bracelet body from the wristband and
plug the charging port into the standard USB
port to charge.)
Left Hand
Sensor