User's Manual

Landing
*
During the connection process, please keep the BlastOff Controller and
Hover 2 within 1 meter of each other.
*
If the connection fails, press and hold the Wi-Fi / RC toggle button
on the drone for 2s, and try to connect again after hearing the beep.
Use the cable of your mobile device (not included
in the package) to connect the BlastOff Controller
and your mobile device.
Method Two: Connect the BlastOff Controller and
Hover 2 with the combination keys
1. Press and hold the two Custom Buttons + Record Button for
two seconds, the Status Indicator Light of the BlastOff
Controller will flash green as it starts to connect Hover 2.
2. The connection is successful when the Status Indicator Light
of the BlastOff Controller is solid green.
Plug the charging cable
into the USB-C Port.
It takes about 2.5 hours
to fully charge.
Unfold the Mobile Device Stand and the Antennas.
第一步 查看电量和充电
遥控器关闭状态下，短按电源键，电量指示灯将显示遥控器
剩余电量。
第二步 准备航拍遥控器
给遥控器充电。
接入 USB-C 充电线 完全充满大约需要 2.5 小时
飞行前请确保航拍遥控器有充足的电量。
Step 1 Check and Charge the Battery
Step 2 Prepare the BlastOff Controller
Step 3 Connect Hover 2
Press and hold the power button for 2 seconds. The
BlastOff Controller will beep when it is successfully
turned on.
Open the Hover 2 app.
Method One: Connect BlastOff Controller and Hover 2 via App
Step 4 Controlling Hover 2
Charge the BlastOff Controller.
长按电源键 2 秒，听到开机声后，遥控器开机成功。
打开 Hover 2 app。
使用移动设备数据线（自备）连接。
Install the Control Sticks.
展开移动设备支架和天线。
固定移动设备。（可打开支架上的卡扣来夹持小尺寸设备）
取出收纳槽中的摇杆并安装。
The default control mode is shown below. You can choose
other control modes in the Hover 2 app.
方法二：通过组合键连接航拍遥控器和 Hover 2
*
连接过程中，请保持航拍遥控器与 Hover 2 相距 1 米以内。
*
若连接失败，请长按机身上的 Wi-Fi / RC 控制模式切换按键 2 秒，
听到嘀声后再次尝试连接。
When the BlastOff Controller is off, press the power
button briefly, and the battery level indicator light will
show the current battery level.
Please make sure that the BlastOff Controller
has sufficient power before flying.
1. 长按组合键（两个自定义按键 + 录像按键）两秒，遥控器状态指示灯
绿灯闪烁，开始连接 Hover 2。
2.连接成功，遥控器状态指示灯绿灯常亮。
使用航拍遥控器控制飞行第四步
摇杆模式默认为美国手。或在 Hover 2 app 里选择
其他摇杆模式。
第三步 连接 Hover 2
方法一：通过 App 连接航拍遥控器和 Hover 2
1 2
1 2
Choose the Controlling Device
BlastOff Controller
Mobile Phone
左摇杆 右摇杆
前进
后退
左 右
上升
下降 左转 右转
Place your mobile device on the Mobile Device
Stand. Use the clamps to secure smaller devices.
Up
Down Turn
Left
Turn
Right
Forward
Left Right Backward
Gimbal Control
云台控制
Left Stick Right Stick
1 螺旋桨加速 2 起飞
1 1
2
降落
Start The Propellers
1
1 1
2
2
Take Off