2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL 2.4G 2.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
.4G 2.4G TRANSMITTER INSTRUCTION MANUAL Catalogue Meaning of special markings Prohibited ntroduction to 2.4G system Regulation and operating procedure of 2.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL To ensure safe use, observe the following precautions. MEANING OF SPECIAL MARKINGS Pay special attention to the safety at the parts of this manual that are indicated by the following marks. , , DANGER Procedures which may lead to a dangerous condition and cause death or serious injury to the user if not carried out properly.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL Night Wind Do not fly in rainy or windy days, or at night. Water will penetrate into the transmitter and cause faulty operation, or loss of control, and cause a crash. Before starting the engine, check the direction of control lever which matched to each servo. If the servo does not move in the proper direction or the operation is abnormal, please do not operate.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL 2.4G Introduction to 2.4G system TWF Company newly designed 2.4G frequency band, 2.4G RC system with advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology, which manifested tremendous vantage compared to traditional transmitter. Traditional remote control distance is about 250meters, required a transmitter with 750mW transmitting power consumption, but 2.4G transmitter just need 4mW power consumption. *2.4 G 2.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL 2.4G Regulation and operating procedure of 2.4G RC System Binding for RC System of each model has been completed in factory, without needing to debug again. Normal operation manifested as below: Power on the transmitter, the indicator of 2.4G transmitter will twinkle for 3 seconds, which indicates that transmitter is sending code binding information. After 3 seconds, the twinkling 2.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL Remarks: Power on the transmitter, indicator twinkles 50times within 3 seconds of binding period, the indicator get solid after the binding.(Please note that in the process of binding, first connect the receiver or 4 in 1 Mix controller before powering on the transmitter) If binding is not successful, the indicator of receiver or 4 in 1 mix controller will twinkle two times then go out.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL TRANSMITTER OPERATION AND THE WORK OF HELICOPTER Before using ,please know the operation of transmitter and the movement of each servo carefully. The following instruction take the transmitter as the keystone . 1 Model 1 (right throttle) When the aileron stick is moved to the left, the swashplate also tilt to the left, and the helicopter moves to the left.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL When the elevator stick is pushed forward, the nose of helicopter will tilt downward, as a result, the helicopter moves forward and its speed decreases. When the elevator stick is pushed backward, the nose of the helicopter will tilt upward, then the helicopter moves backward and its speed increases. When the rudder stick is moved to the right, the tail of helicopter moves to the left and the nose of the helicopter turns to right.
2.4G 2.4G TRANSMITTER INSTRUCTION MANUAL 2 Model 2 (left throttle) When the aileron stick is moved to the left, the swashplate also tilt to the left, and the helicopter moves to the left. When the aileron stick is moved to the right, the swashplate also tilt to the right, and the helicopter moves to the right. When the throttle stick is pushed upward, the speed of the motor and main rotor increases, as a result, the helicopter lifts up. When the throttle stick is pushed downward.