Assembly Instructions

6. Put your mobile phone that
supports wireless charging on
the bracket. It will automatically
clamp the phone and start charging.
5. Insert the type-C charging
cable into the socket and the
other end into the car USB power
output port or car adapter.
4.This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1)this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
4. Insert the clip into the vent of
the car and make the clip clamp
one of the vent fins. Adjust the
support foot to get the right angle
of view.
3. Open the vent clip.
1. Put the fixed nut on the
spinning ball.
2. Insert the spinning ball into the
screw post behind the wireless
charger. Then rotate the fixed nut
to the proper tightness.
Customer Service: [e-mail]
Model
X 1
X 1 X 1
X 1 X 1
Component assembly
Component assembly
With a QC or PD
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
FCC warning