无线领夹式麦克风
产品名称：无线领夹式麦克风 产品型号 充电电流电压 S500 0.5A/5V 充电时长 1.5 H 工作时长 4H以上 连接方式 开机即立即连接 传输距离 正常使用0-20米 产品尺寸 62mm*25mm*20mm 频响范围 20KHZ 收录音声音模式 全指向 供电方式 内置聚合物电池140mA 无线麦克风的使用方式 1.长按麦克风开机键开机，麦克风顶部显示蓝灯，且蓝灯快闪 2.接收器插入手机后，蓝灯快闪 3.自动匹配，5秒后蓝灯慢闪，匹配成功 4.
5.需要听到手机里视频的声音，需拔除手机端的接收器，从手机听取 声音；或者从麦克风低端插入3.5mm 音频耳机，可从耳机听取声音 6.加减增益按键 4 .5 可根据环境合理调整降噪档次，一共8档。短按 “+”键，录音音量加大，降噪效果减小，短按“-”键，录音的音量 减小，降噪效果加大。建议在安静环境下调到最大使用，在吵杂环境 下使用第四档。麦克风关机后，会记忆之前的设置。（戴3.5mm耳机 可以监听调试音量） 无线麦克风的充电使用方法 1.将麦克风插上充电口，指示灯显示红灯，即表示正在充电 2.
1 收录声音位置 2 开/关机键：长按开/关机；按一下关闭/打开耳返 3 连接指示灯 4 增益加键：增益加大，收录声音音量加大，降噪减弱 5 增益减键：增益减小，收录声音音量减小，降噪加强 6 接收器指示灯：未连接成功时快闪，连接成功时慢闪 7 3.5mm音频孔 8 TYPE-C充电口 适用场景 远程授课，运动教学，网络直播，视频录制 备注 1.苹果手机转接头非标配，需另行购买 2.部分安卓手机需要打开OTG模式，方可使用 3.当低电量时，麦克风顶部指示灯红灯闪 4.将麦克风套上防风海绵罩时，效果更佳 5.
Wireless Lavalier Microphones
Product Name: Wireless Lavalier Microphones S500 Product Model Input Voltage S500 0.5A/5V 1.5H Charge Time 1.5 H Battery Life 4H+ Connect Way Connect immediately after power on Work Distance Working distance is 0-20 meters for normal occasion 50 meters Frequency Range Polar Pattern 140mah Power Source 62mm*25mm*20mm 20KHZ Omnidirectional Polymer battery 140mAh How to use wireless lavalier microphone 1.Long press the power on button to turn it on until the blue light flashes. 2.
5.You wanna hear the voice of the video in the cellphone, please unplug the receiver and listen to the voice from the mobile phone, or simply plug a 3.5mm Mic into your headphone jack. 6.+ / - button. 8 model to adjust the noise reduction level according to surroundings. Press + button to increase volume and decrease the noise reduction effect; Press - button to decrease volume and increase the noise reduction effect.
1 Ecording position 2 Power on/off: Long press the button to turn it on, press once the button to close/open the monitor earphone 3 Connect indicator light 4 + button: Press the button to increase volume and decrease the noise reduction effect; 5 - button: Press the button to decrease volume and increase the noise reduction effect. 6 LED light indicator of the receiver: Flash fast when not connected and flash slowly when connect successfully 7 3.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
