User's Manual

-36-
(DLE EOT, DLE ENQ, DLE DC4) until it is enabled by this command.
[Default] n = 1
ESC ? n
[Name] Cancel user-defined characters
[Format] ASCII ESC ? n
Hex 1B 3F n
Decimal 27 63 n
[Range] 32 ≤ n ≤ 126
[Description] Cancels user-defined characters.
[Details] • This command cancels the pattern defined for the character code specified by
n. After the user-defined characters is canceled, the corresponding pattern for
the internal character is printed.
• This command deletes the pattern defined for the specified code in the font
selected by ESC !.
• If a user-defined character has not been defined for the specified character
code, the printer ignores this command.
[Reference] ESC &, ESC %
ESC @
[Name] Initialize printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
[Description] Clears the data in the print buffer and resets the printer mode to the mode that
was in effect when the power was turned on.
[Details] • The DIP switch settings are not checked again.
• The data in the receive buffer is not cleared.
• The macro definition is not cleared.
• The NV bit image data is not cleared.
• The data of the user NV memory is not cleared.
ESC D n1...nk NUL
[Name] Set horizontal tab positions
[Format] ASCII ESC D n1...nk NUL
Hex 1B 44 n1...nk 00
Decimal 27 68 n1...nk 0
[Range] 1 ≤ n ≤ 255
0 ≤ k ≤ 32
[Description] Sets horizontal tab positions.
• n specifies the column number for setting a horizontal tab position from the
beginning of the line.
• k indicates the total number of horizontal tab positions to be set.
[Details] • The horizontal tab position is stored as a value of [character width ╳ n]
measured from the beginning of the line. The character width includes the
right-side character spacing, and double-width characters are set with twice the
width of normal characters.
• This command cancels the previous horizontal tab settings.