User's Manual

-52-
[Description] Selects the character height using bits 0 to 2 and selects the character width using
bits 4 to 7, as follows:
Bit Off/On Hex Decimal Function
0
1
2
3
Character height selection. See Table 2.
4
5
6
7
Character width selection. See Table 1.
Table 1 Table 2
Character Width Selection
Hex Decimal Width
00 0 1(normal)
10 16 2(double-width)
20 32 3
30 48 4
40 64 5
50 80 6
60 96 7
70 112 8
Table 1 Table 2
Character Height Selection
Hex Decimal Width
00 0 1(normal)
10 16 2(double-height)
20 32 3
30 48 4
40 64 5
50 80 6
60 96 7
70 112 8
[Details] · This command is all characters (alphanumeric and Kanji) effective except for
HRI characters.
· If n is outside of the defined range, this command is ignored.
· In standard mode, the vertical direction is the paper feed direction, and the
horizontal direction is perpendicular to the paper feed direction. However,
when character orientation changes in 90° clockwise-rotation mode, the
relationship between vertical and horizontal directions is reversed.
· In page mode, vertical and horizontal directions are based on the character
orientation.
· When characters are enlarged with different sizes on one line, all the