User's Manual
-70-
• When the printer model used ZJports GS P, the left-side character spacing is
[n1
╳
horizontal or vertical motion units], and the right-side character spacing is
[ n2
╳
horizontal or vertical motion units].
[Details] • When double-width mode is set, the left- and right-side character spacing is
twice the normal value.
• The horizontal and vertical motion units are set by GS P. The previously
specified character spacing does not change, even if the horizontal or vertical
motion unit is changed using GS P.
• The value cannot be less than the minimum horizontal movement amount, and
must be in even units of the minimum horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode,
depending on starting position of the printable area as follows:
① When the starting position is set to the upper left or lower right of the
printable area using ESC T, the horizontal motion unit ( x) is used.
② When the starting position is set to the upper right or lower left of the
printable area using ESC T, the vertical motion unit ( y) is used.
③ The maximum right-side spacing is 255/180 inches for the paper roll and is
approximately 35.983 mm {255/150 inches}. Any setting exceeding the
maximum is converted to the maximum automatically.
[Default] n1 = 0, n2 = 0
[Reference] GS P
FS W n
[Name] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII FS W n
Hex 1C 57 n
Decimal 28 87 n
[Range] 0 ≤ n ≤ 255
[Description] Turns quadruple-size mode on or off for Kanji characters.
• When the LSB of n is 0, quadruple-size mode for Kanji characters is turned off.
• When the LSB of n is 1, quadruple-size mode for Kanji characters is turned on.
[Details] • Only the lowest bit of n is valid.
• In quadruple-size mode, the printer prints the same size characters as when
double-width and double-height modes are both turned on.
• When quadruple-size mode is turned off using this command, the following
characters are printed in normal size.
• When some of the characters on a line are different in height, all the characters
on the line are aligned at the baseline.
• FS ! or GS ! can also select and cancel quadruple-size mode by selecting
double-height and double-width modes, and the setting of the last received
command is effective.
[Default] n = 0
[Reference] FS !, GS !