Shenzhen NewStone Technology Co., Ltd.
Please read the manual before using the product and keep the manual for future use. Safety information ɿ This product is strictly prohibited for children under 8 years old, avoid accidents, children over 8 years old should be played in the presence of their guardian and not allowed to leave their guardian’s sight. Please keep this product out of reach of children when charging and saving.
Function description Front left light Tail Front right light Taillights/Highlighted brake lights Recharging hole: connect Type-C line Pin Forward/backward Forward/backward Turn right/turn left Switch power charging indicator light Chassis lights Chassis lights Chassis lights Chassis lights Prepare for run 1 Charging Take the rc car and accessories out of the box, it can be charged on the following two ways when the cars is power off; (Please charge the rc car before the first use) Tip: When the ca
1 .Use the hidden Type-C port on the remote to charge the car.(Picture A-J) A.Turn the coin button clockwise 90° B. from the bottom of the remote , take out the battery box 4x 1.5V (AAA) Rotate 90° counterclockwise C. Install four AAA batteries according to the polarity mark on the battery case bracket D. Install the battery box. Insert the battery box into the handle and rotate coin button 90° counterclockwise. The battery box is installed.
G G. The push rod rotate 90° clockwise done, launch port finished. H H. The remote and the car must be off at the same time, and then plug the car into the remote charging port for charging. J I /('⚥Ӥ ➺⚣ I. After the vehicle is plugged into the charging port, switch the remote switch to the charging mode. J. Then the default red led of the remote is long light. If the charging led light of the remote is off, means the charging is completed.
2 Turn on/off the power of the car Turn on the car: Turn on the power switch (switch to "ON" position), After the LED lights on for 1 second, the car is power on. Switch power If the car’s headlight solid, the binding procedure is completed. The car's headlight flashing indicates that the car needs binding. Turn off the car: turn off the power switch, (switch to "OFF" position), the LED goes off and the the car is power off.
1 Functions Transmitter 1. Throttle: Control forward / brake / backward. 2. Steering wheel: control left / right steering 15 13 14 18 17 16 3. Multi function indicator LED: LED indicator 4. Steering Rev: use the reverse steering switch to reverse the left and right directions. 5. Throttle fine adjustment: when the trigger is in the neutral position, if the car moves forward or backward, please use the throttle fine adjustment. 6. Three section throttle speed limit switch: 20% / 50% / 100%. 7.
3 4 battery compartment charging port push rod battery compartment coin button 5 charging mode RGB multi-color light 2 Install and remove the remote control handle 1. Press the button 2. take away the handle 3. Press and hold the remove button and push the handle inside Tips: Pay attention to the direction of the handle Note: if the handle of remote is in a wrong direction , it will not be powered on. Please install the handle correctly according to the instructions.
3 Transmitter battery installation This remote uses AAA battery or Ni MH battery, when the voltage is lower than 4.5V ± 0.2V, the LED starts flashing. 4x 1.5V (AAA) Rotate 90° clockwise A. Find the coin button of the battery compartment from the bottom of the remote and turn it 90 ° clockwise. Then the battery compartment can be taken out; Install four AAA batteries according to the polarity mark on the battery. WARNING: DO NOT ATTEMPT TO CHARGE A NON RECHARGEABLE BATTERY, OR IT WILL EXPLODE.
5 Car running settings Forward/speed up Left Right / 5 Brake /Revrse Forward/ speed up Neutral Brake /Revrse TH LIM TH-DR ST-DR ST-REV TH-TRIM ST-TRIM Reverse 1. TH/TRIM: When the throttle trigger is in the middle point, if the car is moving forward or backward, please adjust it with TH/TRIM “+” or “-”button. 2. ST/TRIM: When the steering wheel in the middle position, if the front wheel is not in a straight line, please adjust it with ST/TRIM “+” or “-”button. 3.
Specification Product name 1:76 remote control car Driving distance Scale 1:76 30m Driving time Slope angel 30° Size Drive mode Two-wheel drive Proportional steering Proportional steering 30min 60x26.5x17.5mm Weight 15g Battery parameter 3.
Troubleshooting Fault symptom Cause of failure 1. Distance is too far The tranmitter connection failed Make sure that the product is in car receiving mode.(The headlights flash). 2.
Precaution ● This product includes the small parts, there is a risk of suffocation, children under 3 years old are not allowed. ● The car contains lithium batteries. Disassembling, striking, squeezing or throwing the car into the fire is prohibited. If severe swelling occurs, do not continue to use it. Do not place it in high-temperature environment.
Disassembling 1. Dismantle the hull: 1.Hold the front wheel with one hand , and other hand hold the head of the car 2.Then gently push out and take it out 2. Install the hull: 1. An exhaust fixture inserted into the tail of the car chassis 14 2.
Shenzhen NewStone Technology Co., Ltd. Manufacturer: Shenzhen NewStone Technology Co., Ltd. Address: Yuhong Industrial Park, No.20 Xingye West Road, ShaJing Town, Bao'an District, Shenzhen, Guangdong Province If this product can not operate normally during the warranty period, please contact the local distributor or manufacturer that sold this product to obtain warranty service. When the product is under warranty, please show the product warranty card and proof of whether it is within the warranty period.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
