User manual
Page 8
PT-7030: User Manual
Rear Panel - Control Connections
®
1 2 3 4 5 6
1. Computer Input (RJ-45 connector)
Connect a computer or other RS-232 serial device to this input to perform rmware updates to
control the PT-7030 remotely via RS-232.
Note: This is an RS-232 type serial connection using an RJ-45 connector. This input MUST
be connected to an RS-232 serial port on a computer or remote control device using an
appropriate (provided) RS-232 to RJ-45 adapter cable. Refer to page 43 for serial cable
pinouts and control codes.
WARNING: DO NOT CONNECT A COMPUTER NETWORK CABLE TO THIS CONNECTOR!
Doing so will result in hardware damage to your computer equipment or the PT-7030.
2. Trigger Outputs (6)
Connect each Trigger Output to one piece of trigger-enabled audio equipment. You can then
congure the PT-7030 to turn on specic trigger-enabled equipment when a certain input is
selected.