User manual

Page 43
PT-7030: User Manual
Infrared (IR) and Serial (RS-232) Remote Control Codes
IR Control Codes
The PT-7030 accepts infrared (IR) remote control codes via several sources:
• the included infrared (IR) remote control
• a programmable remote control programmed with the correct codes
• a direct input from an IR detector (eye) connected to one of the rear-panel connectors
The full list of valid hex codes (for use with a programmable IR remote control) may be downloaded
from the PT-7030 product page on the Sherbourn website.
RS-232 (serial) Control I/O Pinout
The PT-7030 also accepts remote control codes via a standard RS-232 serial connection.
The full list of serial remote control codes may be downloaded from the PT-7030 product page on
the Sherbourn website.
The connector on the rear of the PT-7030 is a standard RJ-45 connector.
WARNING: The RJ-45 connector on the rear panel of the PT-7030 is not an Ethernet
connection. DO NOT attach a standard computer network Ethernet cable to this input. Doing
so may cause damage to the PT-7030 or your network equipment.
A cable is provided for connecting the PT-7030 to the RS-232 serial output of a PC computer or
remote controller (or any other device which uses a standard serial connection).
NOTE: All serial connections are NOT wired the same, and there is no established standard
for RS-232 connections carried over RJ-45 connectors. Either use the original cable provided
with your PT-7030, or ensure that your cable is wired correctly. Cables provided with other
devices may not work with the PT-7030 (and may even cause damage if used).
The diagram below shows the pinout connections for the provided serial cable, and may be used as
a guide for making custom cables.
!
5
78 69
4 23 1
RJ-45
CONNECTOR
(end view)