Owner`s manual

Page 5
Front Panel
DN----------VOLUME ----------UP
STANDBY 1------------AUTO ------------2
1 5432 6
1. Standby Button
Switches (toggles) the unit between Standby and On.
2. Standby LED
Illuminates red for Standby; blue for On, ashing red for a Fault condition.
3. Infrared Detector Window
Used by the infrared remote control.
4. Input Selector Pushbuttons and Input LEDs
Pressing 1 or 2 manually selects that input; pressing Auto instructs the PA 2-50 to use whichever
input has active audio signal on it. (If both inputs are active, Input 1 has priority.) When each input /
mode is selected, the corresponding LED will illuminate.
5. Volume Up and Volume Down Pushbuttons
Press and hold either button to increase or decrease volume gradually.
6. Volume LEDs (8)
These LEDs indicate the approximate volume setting.
Note: The Volume on the PA 2-50 can be set in very small increments; the LEDs only show an
approximation of the current setting.