User manual
Page 16
SR-8100: User Manual
17. Zone 2 and Zone 3 Buttons
These buttons are used to control the audio being sent to the Zone 2 and Zone 3 outputs. When you
press the Zone 2 or Zone 3 button, the remote control will temporarily control that zone.
The display will switch to indicate that you are now controlling the selected zone; you may then
press the On or Standby buttons to turn the power for that zone On or Off (this includes the output
signal for that zone, and the trigger, if you have assigned one to that zone); you may use the Input
+ and Input - to step between inputs for that zone; and you may use the Vol + and Vol - buttons
to control the audio level for that zone. The remote control will return to normal mode (no longer
controlling the selected zone) a few seconds after you î‚¿nish entering changes.
Note: The Volume and Input Selector Buttons will only accept changes while the zone you
are addressing is turned On. (When each zone is Off, the only command that it will recognize
is On.)