Instructions

WEAR YOUR
FORESIGHT IS BETTER
THAN NO SIGHT
READ INSTRUCTIONS
BEFORE OPERATING
SAFETY GLASSES
SHERLINE PRODUCTS INC. • 3235 Executive Ridge • Vista • California 92081-8527 • FAX: [phone]
Toll Free Order Line: [phone] • International/Local/Tech. Assistance: [phone] • Internet: www.sherline.com
11/17/15
4-Jaw Chuck Hold-Down Set
P/N 3058
About the 4-Jaw Chuck Hold-down Set
This set consists of two clamps complete with screws and
T-nuts, and can be used to clamp the 4-jaw chuck to the
milling table or lathe crosslide. The set provides a little
more versatility than the chuck to T-slot adapter (P/N 1187)
in that the chuck can be located almost anywhere on the
table, and the part can be properly aligned with the axis of
the machine. The clamps t in a groove machined around
the circumference of the 4-jaw chuck. They are the same as
those furnished with the Sherline milling vise (P/N 3551),
so they are not needed if you already own a vise.
NOTE: To keep the surface of your table from being marred,
we recommend you take a le and slightly soften or deburr
all the edges of the angle clamps which contact the table.
Thank you,
Sherline Products Inc.
Parts List
NO.
REQ.
PART
NO.
DESCRIPTION
2 30561 10-32 T-nut
2 35580 Hold-down Clamp
2 40330 10-32 X 5/8" SHC Screw