OPERATING INSTRUCTIONS PM-9805 TURN TABLE T U R N TA B L E
PRECAUTIONS Thank you for purchasing this fine product – STEREO TURNTABLE. Taking time to read these operation instructions carefully. Read this manual carefully before using the unit and be sure to store the manual in a safe place for future reference. 3. Installation precautions Do not install the unit in any of the following locations since this may result in a deterioration in performance or malfunction: • Locations exposed to direct sunlight or near object radiating heat such as heating appliances.
NAME OF THE PARTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18.
CONTENTS ASSEMBLY 6. Installation of cartridge: When installing a cartridge, refer to the operating instructions for that particular cartridge. During installatiion, attach the stylus protector to guard the stylus tip from damage. 1. Please unpack set as confirm following parts. • Turntable platter • Slip Mat • Dust Cover • 45-rpm adaptor • Counterweight • Headshell • Operating Instructions a) Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color coded.
ADJUSTING THE TONEARM Level Balance Adjustment Tracking Force Adjustment 1. Set the ANTI-SKATE knob to “0”. Turning the counterweight, set the correct tracking force opposite the index line on the counterweight shaft. The tracking-force scale ring has 0.25g steps and one full turn of the counterweight will yield a tracking force of 3g. 2. Release the arm clamp and move the tonearm to the space between the arm rest and the platter, taking care not to damage the stylus. 3.
CONTROLS AND OPERATION 7. Move the tonearm over he desired groove. 1. Turn the (On/Off Switch) clockwise to turn on the power, the speed indicator and the strobeilluminator, which is located beneath the On/Off switch, will light up. 8. Set the cueing lever to the down position, the tonearm will descend slowly onto the record and begin playing. 2. Place a record on the slip mat. When playing a 45rpm record with a large center hole, place the 45rpm adapter on the center spindle. 9.
CONNECTIONS This should be firmly connected to the ground terminal on the mixer. The way in which the phono cables are attached will depend on the type of cartridge used. Read the instructions in the booklet that comes with the cartridge as well as the operating instructions of the mixer and connect the phono cables properly. This set’s phono cables and ground lead are attached to the rear panel of the turntable.
STYLUS REPLACEMENT CONNECTIONS The life expectancy of the stylus tip is 500 hours. For the sake of maximum sound quality reproduction, we recommend replacement within the minimum time limit. 1. The stylus tip is replaced by grasping the stylus holder and pulling it away from the body of the cartridge. 2. The new stylus tip s then inserted by pushing it into the receptacle. CARTRIDGE REPLACEMENT CONNECTIONS Remove the headshell from thd tonearm, and the screws that hold the cartridge.
GENERAL SPECIFICATION 1. APPLICATION : This spectftcation applies to the belt drive turntable unit PM-9805 2. STANDARD TEST CONDITION : 2-1 Ambient Temperrature 2-2 Relative Humidity 23 A 2LC 65% A 5% NOTE : Measurements can be carried out betwee 5LC and 45% to 85% relative humidity. 3.
TROUBLE SHOOTING Sometimes, an operational fault can be mistaken for a malfunction or failure. Check the following points and see if you can find the symptoms of the trouble below before you get in touch with the serviceman. If you cannot locate the symptoms, contact your nearest dealer. Remedy Possible Trouble Symptom Platter does not rotate. Power cord is unplugged. Plug cord securely into wall outlet. No Sound Phono cables are not connected properly.