Operating instructions

Continued

When selecting the ROOM 2

OFF : To turn off the ROOM 2 function.

ON : To turn it on.

Notes:

• When the ROOM 2 is set to OFF, the INPUT, the VOLUME, the BASS and the TREBLE cannot be selected.

• When you do not use the ROOM 2 function, set the ROOM 2 to OFF to save electricity.

When selecting the INPUT

• You can select the desired among MAIN source, TUNER, CD, AUX, TAPE, VIDEO 1 ~ VIDEO 4 as a

ROOM 2 source.

Note:

• When the EXTERNAL IN is selected as a main input, if the MAIN source is selected as a ROOM 2 input, no

audio signal can be heard in the different room (ROOM 2).

When selecting the VOLUME

• You can adjust the volume on the power amplifier assigned to "BACK ROOM 2" or "ROOM 2" when

the ROOM 2 speaker terminals are connected to the speakers in a different room.

Note:

• You can adjust the VOLUME only when the surround back channels' power amplifier is assigned to "BACK

ROOM 2" or "ROOM 2". (For details, refer to "When selecting the AMP ASSIGN" on page 52.)

When adjusting the tone (BASS and TREBLE)

1. Press the CURSOR UP( )/DOWN( ) buttons to select the desired tone mode.

2. Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the selected tone as desired.

• The tone level can be adjusted within the range of -10 ~ +10

dB.

• In general, we recommend the bass and treble to be

adjusted to 0 dB (flat level).

• Extreme settings at high volume may damage your

speakers.

• To complete tone adjustment, repeat the above steps 1

and 2.