O P E R A T I N G I N S T R U C T I O N S AUDIO/VIDEO RECEIVER R-925 OPTI COAX VCR1 REC CINEMA BASS DVD LDP AUX SOURCE Pro Logic DIGITAL POWER ST 3 Stereo TAPE 2M TUNED AUTO MEMOTY PRESET DSP THEATER HALL STADIUM T.2 MONITOR DYNAMIC RANGE SLEEP INPUT SELECTOR/ INDEX SLEEP SUBWOOFER FREQ.DIRECT MEMORY / ENTER 1 2 3 4 5 6 7 8 9 0 BAND DIGITAL INPUT PHONES VCR 1 REC STANDBY REMOTE SENSOR RF MASTER VOLUME DYNAMIC RANGE VID.
Introduction UNPACKING AND INSTALLATION ENGLISH Congratulations on Your Purchase! Your new high fidelity receiver is designed to deliver maximum enjoyment and years of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help ensure a trouble free installation. Please unpack your unit carefully. We recommend that you save the carton and packing material.
FOR U.S.A. AND CANADA ..................................120 V FOR OTHER COUNTRIES ....................... 110 V/220 V FOR YOUR SAFETY FOR YOUR SAFETY Units shipped to countries other than the above countries are equipped with an AC voltage selector switch on the rear panel. Refer to the following paragraph for the proper setting of this switch. Units shipped to the U.S.A. and Canada are designed for operation on 120 V AC only. Safety precaution with use of a polarized AC plug.
System Connections ENGLISH Do not connect the receiver to the wall AC outlet when plugging and unplugging connection cords. Be sure to connect the white plugs to the L (left) and the red plugs to the R (right) jacks when making connections. Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations. A 75 Ω outdoor FM antenna may be used to further improve the reception. Disconnect the indoor antenna before replacing it with the outdoor one.
■ CONNECTING MULTI- ROOM ADAPTOR L MULTI ROOM R AC INPUT ~120V / 60Hz FRONT SPEAKERS(8Ω) ANTENNA MAIN IN PHONO DIGITAL INPUTS AC-3 RF L VIDEO L R AM LOOP + DVD PRE OUT CENTER + R PRE OUT CD VCR 1 PLAY TAPE 1 PLAY VCR 1 REC R L - - COAXIAL SUB WOOFER AC-3/PCM - MODEL NO. R-925 - AUDIO/VIDEO RECEIVER OPTICAL FM 75Ω REAR PRE OUT L AC-3 RF COAXIAL Component with COAXIAL DIGITAL OUT TV/AUX GND L + AC OUTLETS + SER.
ENGLISH ■ AC INPUT CORD ■ MAIN IN connections L Pre amplifier R Plug this cord into a wall AC outlet MAIN IN PRE OUT PRE OUT L R ANTENNA MAIN IN PHONO DIGITAL INPUTS AC-3 RE L VIDEO L R R AM LOOP PRE OUT CENTER • When a separate pre amplifier is used for front channels, connect these jacks to the pre amplifier and connect the front speakers to this receiver.
DYNAMIC RANGE BUTTON/INDICATOR VIDEO LABELS BUTTON VCR1 RECORD BUTTON TAPE2 MONITOR BUTTON INPUT SELECTOR / INDEX KNOB MASTER VOLUME CONTROL KNOB POWER BUTTON SLEEP BUTTON REMOTE SENSOR STANDBY INDICATOR DIGITAL INPUT INDICATORS AUDIO/VIDEO RECEIVER R-925 OPTI COAX VCR1 REC CINEMA BASS DVD LDP AUX SOURCE DIGITAL Pro Logic POWER ST 3 Stereo TAPE 2M TUNED AUTO MEMOTY PRESET DSP THEATER HALL STADIUM T.2 MONITOR DYNAMIC RANGE SLEEP INPUT SELECTOR/ INDEX SLEEP SUBWOOFER FREQ.
DIGI LINK III System Remote controls ENGLISH Note : In the United States, the R-925 is shipped with a Universal Illuminated Pre-programmed Remote Control(RNC-100). When using this manual for instructions that require pressing buttons on the remote control, it will be necessary to press different buttons than those shown here. Please see the owner`s manual supplied with the remote for the corresponding buttons.
AUDIO/VIDEO RECEIVER R-925 VCR 1 REC T.2 MONITOR STANDBY REMOTE SENSOR RF MASTER VOLUME DYNAMIC RANGE VID.LABELS MULTI ROOM OPTI COAX VCR1 REC CINEMA BASS DVD LDP AUX SOURCE DIGITAL Pro Logic POWER ST 3 Stereo TAPE 2M TUNED AUTO MEMOTY PRESET DSP THEATER HALL STADIUM DYNAMIC RANGE SLEEP INPUT SELECTOR/ INDEX SLEEP SUBWOOFER FREQ.
Operations ENGLISH Note : In the United States, the R-925 is shipped with a Universal Illuminated Pre-programmed Remote Control(RNC-100). When using this manual for instructions that require pressing buttons on the remote control, it will be necessary to press different buttons than those shown here. Please see the owner`s manual supplied with the remote for the corresponding buttons. LISTENING TO A PROGRAM SOURCE 1 Turn the power on. 3 Select the desired input source. T.
Select the digital (or the analog) input connected as desired. Each time this button is pressed, the corresponding input is DIGITAL INPUT selected as follows; – In the normal stereo or a surround mode other than the Dolby DIGITAL(AC-3) mode. OPTICAL COAXIAL Adjust the stereo balance between the left and the right channels. BALANCE LEFT 8 RIGHT Adjust the subwoofer level.
SURROUND SOUNDS The R-925 incorporates a sophisticated Digital Signal Processor that allows you to create the optimum sound quality and the sound atmosphere in your room. ENGLISH Surround modes This receiver has 7 different surround modes to allow you to enjoy surround sound with the various program sources: DOLBY DIGITAL(AC-3), DOLBY PRO LOGIC, DOLBY 3 STEREO, THEATER, HALL,STADIUM,CHURCH. DOLBY DIGITAL(AC-3) : Allows you to enjoy up to 5.
Speaker placement TV set FRONT LEFT To obtain the best surround sound effect in your home, place the speakers as follows; Front speakers : Place each front speaker about 1m (40”) from the TV set. Center speaker : Place the center speaker either above or below the TV set to assure good visualization of center channel program. Rear speakers : Place the rear speakers approximately 1m above the ear level of a seated listener on the direct left and right of them or slightly behind.
Adjusting the speaker settings 5 ENGLISH Adjusting the setting of the center speaker and the subwoofer connected. 2 Press the SPEAKER MODE button for more than 2 seconds to enter the center speaker mode. Select the desired subwoofer mode. SPEAKER MODE SPEAKER MODE Each time this button is pressed,the subwoofer mode changes and flickers as follows; YES : When using a subwoofer. NO : When not using a subwoofer.
7 Press the TEST TONE button to adjust the volume level of each speaker. D.TIME • The delay time will be displayed for 5 seconds. • In Dolby DIGITAL(AC-3) mode, the corresponding delay time will be flickering. • The center delay time can be adjustable only in Dolby DIGITAL(AC-3) mode. • The rear delay time can be adjustable only in Dolby DIGITAL(AC-3) and Dolby Pro Logic modes. T.
LISTENING TO RADIO BROADCASTS ENGLISH 1 Select the tuner. Manual tuning is useful when you already know the frequency of the desired transmitter. or INPUT SELECTOR/ INDEX 2 Manual tuning 3 TUNER Press TUNING - or + repeatedly until the right frequency has been reached. TUNING Select the desired band. TUNING Frequency direct tuning BAND 3 Enter the frequency direct tuning mode. FREQ.DIRECT BAND FREQUENCY Each time this button is pressed, the band is changed to FM or AM.
Presetting radio stations Listening to FM stereo broadcasts You can store up to 30 preferred stations in the memory. While listening to FM broadcasts. 3 4 Each time this button is pressed, the FM mode changes as follows; Press the MEMORY/ENTER button.
AUDIO RECORDING • The digital signals from optical, coaxial or RF digital input can be heard but cannot be recorded. ENGLISH Recording with TAPE 1 1 Recording with TAPE 2 MONITOR Select the desired input as recording source except for TAPE1 and TAPE 2 MONITOR. CD INPUT SELECTOR/ INDEX or 1 Select the desired input as recording source except for TAPE 2 MONITOR.
RECORDING WITH VCR1 Dubbing from video components to VCR 1 Listening to other audio inputs during dubbing Example) When dubbing from LD player to VCR 1 Example) When listening to CD during dubbing from LDP to VCR 1. Select LDP as program source being enjoyed. 1 1 or INPUT SELECTOR/ INDEX Select CD as the program source being enjoyed. LDP INPUT SELECTOR/ INDEX or CD PROGRAM SOURCE being enjoyed. 2 Select LDP as recording source. 2 Select LDP as recording source.
Enjoying other video inputs during dubbing Dubbing and enjoying the audio and video signals separately ENGLISH Example) When enjoying DVD on the TV set and from the speakers during dubbing from LDP to VCR 1. 1 Example) When dubbing and enjoying LD video signal and CD audio signal. Select DVD as the program source being enjoyed. 1 Select source. VCR 1 REC VCR1 REC DVD SOURCE or INPUT SELECTOR/ INDEX DVD 2 INPUT SELECTOR/ INDEX 2 Select LDP as video source within 5 seconds.
5 MEMO / ENTER 7 VCR1 Start recording on the VCR 1. Start play on the LDP. REC LDP 8 SOURCE VIDEO SOURCE AUDIO SOURCE Start play on the CDP. The audio signal from CDP and the video signal from LDP will be dubbed onto the tape in VCR 1 and you can enjoy them on TV set and from the speakers. In the above step, if it elapses 5 seconds, repeat again from the step 1.
Entering video labels 5 ENGLISH It can be operated only on video input sources such as DVD, LDP, VCR 1 and AUX/TV. 1 Rectifying or clearing a video label Select the desired video input source to enter its label. 1 or INPUT SELECTOR/ INDEX Repeat the steps 3 and 4 to memorize the rest of up to 8 characters. Select the desired video input source to be rectified or cleared. DVD VCR1 AUX/TV or LDP INPUT SELECTOR/ INDEX DVD VCR1 2 Press the VIDEO LABELS button for more than 2 seconds. VID.
If a fault occurs, run through the table below before taking your receiver for repair. If the fault persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the situation, consult your dealer. Under no circumstances should you repair the receiver yourself as this will invalidate the guarantee! POSSIBLE CAUSE REMEDY No power PROBLEM The AC input cord is disconnected. Poor connection at AC wall outlet or the outlet is inactive. Connect cord securely.
Specifications AMPLIFIER SECTION ENGLISH Power output, stereo mode, 8 Ω, THD 0.1%, 20 Hz~20 kHz...................................................................................2 ×100 W Total harmonic distortion, 8 Ω, 100 W, 1 kHz................................................................................................................0.02 % Intermodulation distortion 60 Hz: 7 kHz= 4:1 SMPTE, 8 Ω,100 W ...................................................................................................
O P E R A T I N G I N S T R U C T I O N S R-925 AUDIO/VIDEO RECEIVER 5707-04669-001-0 (9007019040)