Operating instructions

ENGLISH
15
TONE
TUNE
• Each time these buttons are pressed, the tone mode is
selected as follows :
OFF : To listen to a program source without the
↕ tone effect.("DIR" lights up.)
ON : To adjust the tone for your taste.("DIR" goes off.)
• Each time these buttons are pressed, the tone is selected as
follows:
→ BASS ↔ TREBLE ↔ TONE: ON ←
■When the TONE is set to ON to adjust the tone
(bass and treble).
• The tone level can be adjusted within the range of -10 ~
+10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
• If the tone display disappears, start from the step 9 again.
Adjusting the tone (bass and treble)
TO O FF NE :
FM MH P0 1
-30
z.
50 87
• The tone mode is
displayed for several
seconds.
9. Enter the tone mode.
10. Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to select the desired tone mode.
11. Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired tone.
12. Press the CURSOR LEFT(◀)/RIGHT(▶)
buttons to adjust the selected tone as desired.
PRESET
• Be sure to switch the speakers off.
• When listening to a DTS or Dolby Digital program source,
if the headphones are plugged in and the SPEAKER
button is set to off, it enters the 2CH downmix mode
automatically. (For details, refer to “2CH downmix
mode”on page 17.)
■Note:
• Be careful not to set the volume too high when using
headphones.
• When playing back the program sources with surround
sound, refer to “ENJOYING SURROUND SOUND” on
page 17.
• “MUTING” is displayed.
• To resume the previous sound level, press it again.
MASTER VOLUME
DOWN UP
MUTE
PHONES
5. Operate the selected component for playback.
6. Adjust the (overall) volume.
7. To mute the sound.
8. To listen with the headphones.
RD-606i(G)_ENG_110511_RD-606i(G)_ENG 2011-05-13 오전 9:57 페이지 15