Manual

IRD-6504(A)_ENG:RD-6504(A)2009-02-12£ 9:03qolml 15 _t _
Operations
IINote : Before operating this receiver, first set this unit as desired for optimum performance, doing the system setup
procedures. (For details, refer to "System Setup" on page 29.)
_ LISTEN|NG TO A PROGRAM SOURCE j
Before operation
o Enter the standby mode.
oThe STANDBY indicator lights up.
This means that the receiver is not
disconnected from the AC mains and a
small amount of current is retained to
support the operation readiness.
oTo switch the power off, push the POWER
switch again.
oThen the power is cut off and the STANDBY
indicator goes off.
POWER
0
_ON re.OFF
1. In the standby mode, turn the power on.
ON/STANDBY
©
o1"
oEach time the POWER ON/STANDBY button on the front
panel is pressed, the receiver is turned on to enter the
operating mode or off to enter the standby mode.
oOn the remote control, press the POWER ON button to
enter the operating mode or press the STANDBY button
to enter the standby mode.
oIn the standby mode, if the INPUT SELECTOR button is
pressed, the receiver is turned on automatically and the
desired input is selected.
2. Switch the speakers on.
0
SPEAKER
©
ON/OFF
oThen the SPEAKER indicator lights up and the sound
can be heard from the speakers connected to the
speaker terminals.
oWhen using the headphone for private listening, press
the SPEAKER button again to switch the speakers off.
3. Select the desired input source.
INPU] SE_ CTOR
VIDO AUDIO
© ©
BAND
@
E) I"
CD
000
CDC?
oEach time the "VIDEO" button on the front panel is
pressed, the input source changes as follows:
VIDEO 1 n VIDEO 2
oEach time the "AUDIO" button on the front panel is
pressed, the input source changes as follows:
CD- AUX- F.AUXTAPEBTIN
I /
oEach time the "BAND" button is pressed, the band
changes as follows:
,_ FMST-_ FMMONO-_ AM --1
| 1
IlWhen selecting the EXTERNAL IN as desired,
o"EXT IN" is displayed and 6 separate analog signals
from the component connected to this input pass
through the tone and the volume circuits only and can
be heard from your speakers,
oSelect the desired input source to cancel the external in
function,
oThese analog signals can be heard only, not recorded,