Manual

IRD-6504(A)_ENG:RD-6504(A)2009-02-12£ 9:03_tlolml20 _
/!
Listening in Virtual Surround Headphone mode
oThe Virtual Surround Headphone mode simulates 5.1 channel surround, which allows you to enjoy 5.1 channel surround
sound through 2 channel hedphones, just like listening from 5.1 channel speakers.
[]Note :
oOnly when the SPEAKER button is set to off, the Virtual Surround Headphone mode can be selected.
o Select the Virtual Surround Headphone mode.
or
oThen "VS HP" is displayed and the Virtual Surround
Headphone mode is selected.
oTo cancel the Virtual Surround Headphone mode, press
the STEREO button.
When adjusting the sound parameters
oWhile playing digital signals from Dolby Digital or DTS program source or listening in Dolby Pro Logic II Music mode, you
can adjust their parameters for optimum surround effect.
1= Press the SOUND PARAMETER button.
SOUND
PARAMETER
oThen "DRC : ~ " (or "PANO • ~ ") is displayed for several
seconds.
o If the parameter mode disappears, press this button again.
2. Press the CURSOR UP(A)/DOWN(v) buttons to select the desired parameter.
D _-_,D o Each time these buttons are pressed, the parameter mode
;:_j ;:j#_ changes as follows:
"DRC" _ "PANO"_ "C.WIDTH"_ "DIMEN" *-
Dynam c Range Compress on Panorama mode Center w dth contro D mens on contro J
o "DRC" can be selected only while playing digital signals
from Dolby Digital or DTS source.
o "PANO", "C.WIDTH" and "DIMEN" can be selected only
while listening in Dolby Pro Logic II Music mode.
3, Press the CURSOR LEFT(_1i)/RIGHT(I_) buttons to adjust the selected parameter as desired.
[]When selecting the "DRC (Dynamic Range Compression :
Night mode)"
This function compresses the dynamic range of previously
specified parts of Dolby Digital or DTS sound track (with extremely
high volume) to minimize the difference in volume between the
specified and non-specified parts. This makes it easy to hear all of
the sound track when watching movies at night at low levels. The
night mode can be set in 11 steps from OFF(0.0) to MAX(1.0)
(default value : OFF(0.0)).
[]Note :
oIn some Dolby Digital or DTS softwares, the night mode may not
be valid.