Manual

I RD 6504(A)_ENG:RD 6504(A) 20090212 £ 9:03 qolml 22 _

Adjusting the current channel level

oAfter adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit

you r tastes.

oYou can adjust the current channel levels as desired. These adjusted levels are just memorized into user's memory ("CAL"),

not into preset memory("REF 1 ", "REF 2").

1, Press the CHANNEL LEVEL button.

:w., _ t { . L_ .%. --.

oThen the memory mode ("REF 1", etc.) is displayed for

several seconds.

oWhen the memory mode or channel level disappears,

press this button again.

2, Select the desired channel.

v CONTROL A

I II I

C_3 'i_{bJ_:JiLJ

o Each time these buttons are pressed, the corresponding

channel is selected as follows:

F, C FR

DTSor DD> SW _ SL _ SR

< >: Only when the digital signals from Dolby Digital or DTS

program sources that include LFE signal are input, LFE level

can be displayed.

,, Depending on the speaker settings ("N (None or No)") and

surround mode, etc., some channels cannot be selected.

oWhen the SPEAKER button is set to off, only the Front

Left and Front Right channels can be selected.

3, Adjust the level of the selected channel as desired.

oThe LFE level can be adjusted within the range of -10~0

dB and other channel levels within the range of -15 ~ +15

oIn general, we recommend the LFE level to be adjusted

to 0 dB (However, the recommended LFE level for some

early DTS software is -10 dB) If the recommended levels

seem too high, lower the setting as necessary

4, Repeat the above steps 2 and 3 to adjust each channel level.