Operating instructions

ENGLISH
20
• While playing digital signals from Dolby Digital or Dolby TrueHD program source or listening in Dolby Pro Logic II/Dolby Pro
Logic IIx Music mode or Dolby Pro Logic IIz mode, you can adjust their parameters for optimum surround effects.
• Then the parameter mode ("PANORAMA : ~ ", “DRC : ~”,
etc.) is displayed for several seconds.
• If the parameter mode disappears, press this button again.
When adjusting the Dolby Pro Logic II Music parameters
1. Press the SOUND PARAMETER button.
PRESET
2. Press the CURSOR UP(▲)/DOWN(▼) buttons
to select the desired parameter.
• Each time these buttons are pressed, the parameter mode
changes as follows:
→"PANORAMA" ↔"C.WIDTH" ↔"DIMENSION" ←
• "PANORAMA", "C.WIDTH" and "DIMENSION" can be
selected only while listening in Dolby Pro Logic II Music
mode or Dolby Pro Logic IIx Music mode.
• "DRC" can be selected only while playing digital signals
from Dolby Digital or Dolby TrueHD program source.
• "H.GAIN" can be selected only while listening in Dolby Pro
Logic IIz mode.
■When selecting the "PANORAMA" mode
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect with
side wall imaging.
Select "OFF" or "ON"(default value: OFF).
■When selecting the "C. WIDTH (Center width)"
control
This adjusts the center image so it may be heard only from
the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying
degrees.
The control can be set in 8 steps from 0 to 7(default value :
3).
■When selecting the "DIMENSION" control
This gradually adjusts the soundfield either towards the
front or towards the rear. The control can be set in 7 steps
from -3 to +3 (default value : 0).
TUNE
3. Press the CURSOR LEFT(◀)/ RIGHT(▶)
buttons to adjust the selected parameter as
desired.
■To cancel the surround mode for stereo operation
• Depending on the signal format which is being input, either the
stereo mode or the 2CH downmix mode is selected.
• To cancel either the stereo mode or the 2CH downmix
mode, select the surround mode with using the SURROUND
MODE UP/ DOWN (>/<) buttons.
■2CH downmix mode
• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format to be mixed down into 2 front channels and
to be reproduced through only two front speakers or through headphones.
• When the SPEAKER button is set to off to listen with headphones while playing the multi-channel digital signals from DTS or
Dolby Digital sources, it will enter the 2CH downmix mode automatically.
STEREO
Continued
→ "H.GAIN" ↔"DRC" ←
RD-705i(G)_ENG_101206_RD-705i(G)_ENG2010-12-07오전10:24페이지20