Operating instructions
ENGLISH
22
Adjusting the current channel level
• Each time these buttons are pressed, the corresponding
channel is selected as follows:
→REF1, 2(or CAL)↔LEFT[↔FH LEFT]↔CENTER[↔FH RIGHT]↔RIGHT ←
→<DD or DTS>↔SUBW ↔SURR L(↔SBACK L↔SBACK R)↔SURR R ←
( ) : Possible depending on whether the surround back speaker is
set to 2ch(“L2”, “S2”) or 1ch(“L1”, “S1”).
[ ] : Possible only when the front height speaker is not set to “NO”.
< >: Possible only when the digital signals from Dolby Digital, DTS,
Dolby TrueHD or DTS HD program sources that include LFE
signal are input.
• Depending on the speaker settings ("NO") and surround
mode, etc., some channels cannot be selected.
• When the SPEAKER button is set to off, only the Front
Left, Front Right (and LFE) channels can be selected.
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit
your tastes.
• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory ("CAL"),
not into preset memory("REF 1", "REF 2").
• The LFE level can be adjusted within the range of -10 ~ 0 dB
and other channel levels within the range of -15 ~ +15 dB.
• In general, we recommend the LFE level to be adjusted to
0 dB.(However, the recommended LFE level for some
early DTS software is -10 dB.) If the recommended levels
seem too high, lower the setting as necessary.
CH.LEVEL
PRESET
• Then the memory mode ("CAL", etc.) is displayed for
several seconds.
• When the memory mode or channel level disappears,
press this button again.
TUNE
1. Press the CHANNEL LEVEL button.
2. Select the desired channel.
3. Adjust the level of the selected channel as
desired.
4. Repeat the above steps 2 and 3 to adjust each
channel level.
IVO1D (HDMI 1)
:CAL
E
MO DE
HDMIAT
RD-705i(G)_ENG_101206_RD-705i(G)_ENG2010-12-07오전10:24페이지22