Operating instructions
ENGLISH
48
Continued
• If possible, use a tripod, etc. to attach the microphone at the same height as your ears would be when you are seated in your
listening position.
• Ensure there are no obstacles between the speakers and the microphone.
1. Place the microphone on a flat level surface at the listening position.
• Loud test tones are output successively and then if a series of auto setup procedure has been completed, the results are
memorized and the previous menu is displayed.
• To stop the auto setup procedure while performing it, pess the AUDIO ASSIGN(/RETURN) button or the SETUP (/MAIN
MENU) button.
• If there may be a problem with front speakers or microphone connection, error message will be displayed. In this case, turn off
the power, check the connection and then retry the auto setup procedure.
• Check the results on each setup menu (SPEAKER CONFIGURATION menu on page 50, SPEAKER DISTANCE menu on
page 52 and CH LEVEL SETUP menu for “CAL” mode on page 53).
• If the results are not satisfactory, you can retry the auto setup procedure or personalize your speaker setup and channel
level setup by making the settings manually. (For details, refer to "When selecting the SPEAKER CONFIGURATION" on
page 50, "When selecting the CROSSOVER" on page 51, "When selecting the SPEAKER DISTANCE" on page 52,
"Adjusting each channel level with test tone" on page 21 and "Adjusting the current channel level" on page 22.)
■Notes :
• Because the test tones are loud, ensure there no infants or small children in the room.
• For best results, ensure the room is as quiet as possible during the auto setup procedure.
If there is too much ambient noise, the results may not be satisfactory.
2. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the “AUTO SETUP”, then press the ENTER button.
RD-705i(G)_ENG_101206_RD-705i(G)_ENG2010-12-07오전10:25페이지48