Operating instructions

ENGLISH

SETTING THE CH LEVEL SETUP

■Note : Depending on the speaker settings ("NO", etc), some channels cannot be selected.

• The LFE level can be adjusted within the range of -10 ~ 0

dB and other channel levels within the range of -15 ~ +15 dB

• In general, we recommend the LFE level to be adjusted to

0 dB.(However, the recommended LFE level for some

early DTS software is -10 dB.) If the recommended levels

seem too high, lower setting as necessary.

MODE : CAL / REF 1 / REF 2

LEFT : 0 dB / -15 ~ + 15

CENTER : 0 dB / -15 ~ + 15

RIGHT : 0 dB / -15 ~ + 15

SURR R: 0 dB / -15 ~ + 15

SBACK R : 0 dB / -15 ~ + 15

SBACK L : 0 dB / -15 ~ + 15

SURR L : 0 dB / -15 ~ + 15

SUBW : 0 dB / -15 ~ + 15

DD : 0 dB / -10 ~ 0

DTS : 0 dB / -10 ~ 0

RETURN

CH LVL SETUP

1. Press the CURSOR UP(▲)/DOWN(▼) buttons

to select the desired channel.

2. Press the CURSOR LEFT(◀)/RIGHT(▶)

buttons to adjust the level of the selected

channel or program source's LFE as desired.

3. Repeat the above steps 1 and 2 to adjust each

channel level.

• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory("CAL"),

not into preset memory ("REF 1", "REF 2")

• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit

your tastes. (For details, refer to "Adjusting each channel level with test tone" on page 21.)

Adjusting the current channel level

dBD :

Example: When selecting Dolby Digital source's LFE

RD-705i(G)_ENG_101206_RD-705i(G)_ENG2010-12-07오전10:25페이지53