Operating instructions
ENGLISH
42
* In case of selecting “AP List”
• This unit searches for all available wireless routers.
• Depending on whether security code is required or not
while configuring network settings, “WEP”(“WPA”,
“WPA2”, etc.) or “NONE” is displayed beside the name.
① Press the CURSOR UP(▲)/DOWN(▼) buttons to select
the desired of all available wireless routers, then press
the ENTER button.
• In case that security code is not required, the network
settings are automatically configured and the “Status”
menu will be displayed.
② In case that security code is required, perform the steps
②~⑤ in “Registering your account” procedure on page
37 to enter the sucurity code.
• If the security code is correct, the network settings are
automatically configured and the “Status” menu will be
displayed.
• It it is not correct, press the ENTER button and enter it
again.
AP
st
ON E
Li
1lin Nk sy s /
AT
• Each time the CURSOR UP(▲) or DOWN(▼) button is
pressed, the information changes as follows.
→SSID ↔ IP address ←
→DNS server ↔GW(Gateway) ←
◆When selecting “Status”
3. Press the CURSOR UP(▲)/DOWN(▼) buttons to
check the desired information.
1SS
Statu
s
ID: l
i
nks sy
A
T
• Each time the CURSOR UP(▲) or DOWN(▼) button is
pressed, the information changes as follows.
→Type of this unit ↔Software Version ←
→MAC address ↔WPS PIN ←
• When “OK” is selected, they are reset to the factory
default.
• When “CANCEL” is selected, then the previous status is
returned to without resetting.
◆When selecting “About”
■When selecting “General”
Example : When selecting “Factory Setting”
• When “Factory Settings” is selected, you can reset the
“Playback” settings, “Network” settings and stations or
music files registered in the “favorites” list to the factory
default.
• When “About” is selected, you can check the general
information such as type of this unit, software version,
WPS PIN and MAC address.
◆When selecting “Factory Settings”
3. Press the CURSOR UP(▲)/DOWN(▼) buttons to
check the desired information.
3. Press the CURSOR UP(▲)/DOWN(▼) buttons to
select “OK” or “CANCEL”, then press the ENTER
button.
2. Press the CURSOR UP(▲)/DOWN(▼) buttons to
select “Factory Settings” or “About”, then press
the ENTER button.
1
Gener
Facto
al S
e
tti gn
r
y
Se tt
A
T
1In
Abou t
tern
e
tAdu
A
T
1
Wa r n i
OK
ng :
A
ll es
AT
RD-705i(A)_ENG_101206_RD-705i(A)_ENG2010-12-06오후2:43페이지42