User's Manual

ManualsBrandsSherwood ManualsStereo AmplifierSherwood Sherwood Stereo Amplifier AX-5103

Operations

LISTENING TO A PROGRAM SOURCE

Before operation

In the standby mode, turn the power on.

Select the desired input source.

Switch the desired speakers on.

• Enter the standby mode.

• The STANDBY indicator lights up.

This means that the amplifier is not disconnected from

the AC mains and a small amount of current is

retained to support the memorized contents and

operation readiness.

• To switch the power off, push the POWER switch

again, then the power is cut off and the STANDBY

indicator goes off.

• Then the corresponding SPEAKER indicator lights up

and the sound can be heard the speakers connected

to "SPEAKER A" or (and) "SPEAKER B" terminals.

• When using headphones for private listening, press

both SPEAKER SELECTOR A and B buttons to switch

the speakers off.

Note : For safe amplifier operation, be sure to check

impedance of the speakers connected. (Refer to

“CONNECTING SPEAKERS” on page 6)

• Then the corresponding indicator lights up.

• When the TAPE 2 MONITOR button is set to on so that

the TAPE 2 MONITOR indicator lights up, other inputs

can not be heard from the speakers.

To listen to a input source other than TAPE 2

MONITOR, be sure to set the TAPE 2 MONITOR

button to off.

TAPE MONITOR function

You can connect either a tape deck or a graphic

equalizer to the amplifier’s TAPE 2 MONITOR jacks.

Only when you listen to the component connected to

these jacks, set the TAPE 2 MONITOR button to on.

If you connect a 3-head tape deck, you can listen to the

sound being recorded during recording, not the source

sound.

For further details, refer to the operating instructions of

the component connected.

• Each time the POWER button on the remote control

is pressed, the amplifier is turned on to enter the

operating mode or off to enter the standby mode.

• In the standby mode, if the INPUT SELECTOR

button is pressed, the amplifier is turned on

automatically and the desired input is selected.

SYSTEM POWER ON/OFF

• If the POWER switch of Sherwood component

connected by the DIGI LINK II or III is kept pushed

and its AC input cord is plugged in the switched AC

outlet, each time the amplifier becomes the standby

or the operating mode, its power is turned off or on.

• Under the same conditions, if its AC input cord is not

plugged only in the switched AC outlet, when the

amplifier becomes the standby mode, only its display

is off (meaning that a small amount of current is

retained for operation readiness, etc.)

ENGLISH

AX5103(G) 2007.8.17 4:43 PM 페이지 9