OPERATING INSTRUCTIONS ST-4108 ST-4108F/R ST-4108C ASW-4108 H O M E T H E ATER SPEAKER SYS T E M
Introduction UNPACKING AND INSTALLATION READ THIS BEFORE OPERATING YOUR UNIT Congratulations on Your Purchase! Your new speaker-system is designed to deliver maximum enjoyment and years of trouble free service. Please take a few moments to read this manual thoroughly. It will explain the features and operation of your unit and help ensure a trouble free installation. Please unpack your unit carefully. We recommend that you save the carton and packing material.
Rear Panel Controls A S W-4108 ① POWER/VOLUME KNOB ・ Turn this knob to turn the power on, then this unit enters the operating mode. The color of LED turns green. ・ To turn the power off, press this switch again, then the power is cut off and this unit enters the power off mode. ② Low level Input Please connect low level input to Subwoofer input of receiver or amplifer. ③ Control of Phase According to phase, contol it from 0 to 180. If it does not match, low sound range would be decreased.
System Connections ・This ST-4108 is designed to use together with Sherwood’ s products.(amplifier/DVD receiver/etc) Doing so will allow you to operate easily and conveniently. In case of connecting other amplifier or receiver to this unit, contact your dealer or our service organization. ・Never short circuit the + and - speaker cords. ・For proper connections, refer to the operating instructions of the component connected. ・When this unit is placed next to the record player, etc.
Troubleshooting Guide If this unit does not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or our service organization. PROBLEM POSSIBLE CAUSE REMEDY No Power ・The AC input cord is disconnected. ・The POWER switch on the rear panel is not pressed. ・Connect the cord securely. ・Turn the POWER knob to ON. No sound ・Incorrect connection between the components. ・Incorrect operation of the component connected.