Operator`s manual

47
4747
47
INSPECTION AND MAINTENANCE
16. Inspecting the Tire
①
①①
① Inspection of Tire
Check the tires of the front and rear wheels for
proper air pressure. It can be visually checked
as illustrated below.
..
.
Standard air pressure
Tire size
Air pressure
kPa (kgf/cm
2
)
Front
wheel
21×11.00-10-PR 68 (0.7)
Rear
wheel
21×11.00-10-PR 68 (0.7)
Check the tire for damage or crack.
②
②②
② Inspection of wheel fixing bolt
Check each wheel fixing bolt for looseness. If
looseness is noticed, retighten referring to the
values in the table below.
Wheel Tightening torque Nm (kgf·cm)
Front 81.3 ± 9 (810 ± 90)
Rear 81.3 ± 9 (810 ± 90)
17. Color of Exhaust Gas
When the engine is started, a small amount of
black exhaust gas is emitted but usually
exhaust gas is colorless.
Black: ····Imperfect combustion because of too
rich fuel
White:····Engine oil is burning. When the air
temperature is low, exhaust gas may
look white because of steam.
If black or white exhaust gas is emitted without
load, subject the vehicle to service at a dealer.
18. Inspection and Adjustment of Brake
● Check the brake for correct operation. If not
,
an accident may be caused.
P
ress the brake pedal and check for specified
allowance (5 –
10mm) and same functioning on
the right and left sides. If the allowance
of the
pedal is not as specified, remove the ste
p cover
and adjust with the cable from the r
ear wheel
traveling section. If adjustment cannot be
completed at this p
oint, remove the rear wheel
and adjust the adjusting point on the
inside of the
rear wheel
. Check that the parking brake is
properly applied with the parking brake lever.
Warning