Instruction manual

5. Application Operation
5-14
RF-20A/20Axs
 System Settings Group
 Monitor Display Group
Name Operation Function Page
LOCAL Numeric keys
To set whether this instrument is controlled from a system controller
or controlled at the instrument itself.
P. 5 -2 9
LINK ADRS Numeric keys
To set the address if the instrument is controlled from the system
controller.
P. 5 -2 9
KEY CLOSE key To block receipt of inputs from the operation keys. P. 5 -2 9
BRIGHTNESS Numeric keys To set the brightness of the display panel. P. 5 -3 0
EXT-S Numeric keys To set the operation of the EVENT output terminal. P. 5 - 3 0
MONIT-TIME Numeric keys To set whether the time program elapsed time is shown or hidden. P. 5 - 3 1
BEEP MODE Numeric keys To set the buzzer sound. P. 5 -3 1
CELL No. Numeric keys To enter the cell number when a cell is replaced. P. 5 -3 1
Name Operation Function Page
SMPL EN, REF EN Display
To show the light intensity levels of the sample side and reference
side.
P. 5 -3 2
Xe TIME Display To show the cumulative operating time of the Xenon lamp. P. 5 - 32
Xe COUNT Display To show the ignition count of the Xenon lamp. P. 5 -3 3
CELL TEMP
(RF-20Axs only)
Display
To show the current temperature of the flow cell and the set
temperature.
P. 5 -3 3
ROOM TEMP
(RF-20Axs only)
Display To show the ambient temperature of the instrument. P. 5- 3 3
∗ The entry in the "Operation" column indicates the following types of operation.
Display : Check the monitor.
key : Press to activate the function.
Numeric keys : Press - to enter a value, then press to confirm the value.