Instruction manual

5.3 Setting the VP Functions
5-49
RF-20A/20Axs
5
5.3.7 Showing and Setting CBM Parameters (Calibration Support Group)
This is the procedure for showing and setting the
parameters of the CBM-20A/20Alite that controls the
instrument.
Press to go to the CBM parameter setting
screen.
Press or repeatedly to select the item
to be set.
Pressing while any item is selected returns you
to the screen on the right.
NOTE
If the instrument is not connected to a CBM-20A/20Alite or has been set to the local mode, the CBM
parameter setting screen will not be displayed even on pressing .
List of CBM Parameters
∗1 If changes not allowed at the CBM-20A/20Alite, these parameters can only be shown, not changed.
∗2 Cannot be set if [0] (the default gateway is not used) is set.
NOTE
The set parameters take effect when the CBM has been restarted.
Refer to the CBM-20A/20Alite instruction manual for details on each parameter.
CBM PARAMETER
Enter to Select
SERIAL NUMBER To show the serial number of the CBM.
S/W ID To show the program version number of the CBM.
INTERFACE To set the transmitting protocol for communications with the data processing unit.
ETHERNET SPEED To set the Ethernet communications speed.
∗1
USE GATEWAY To set whether the default gateway is used or not.
∗1
IP ADDRESS To set the IP address of the CBM.
∗1
SUBNET MASK To set the subnet mask.
∗1
DEFAULT GATEWAY To set the default gateway.
∗1∗2
TRS MODE To make the communication settings when serial transmissions are used.