Instruction manual

5. Application Operation

5-60

RF-20A/20Axs

5.4.5 Starting a Time Program

There are the following two methods for starting a time

program.

• Press .

• Input contact signals to the external input/output

terminals.

^ "5.8 Connection to External Input/Output

Terminals" P.5-81

The time program indicator on the display panel will

come on and the time program will start.

NOTE

If set values are changed during the execution of a time

program, the values after the changes will be applied

only up until the time program ends. After the time

program has ended, the settings made before the

execution of the time program will be reinstated.

5.4.6 Stopping a Time Program [STOP]

There are the following three methods for stopping a time program.

• Press during the execution of the time program to forcibly end it.

• Send contact signals to the external input/output terminals during the execution of the time program to

forcibly end it.

^ "5.8 Connection to External Input/Output Terminals" P.5-81

• Insert a [STOP] command in the time program.

^ "Example of Creation of a Time Program" P.5-57

Time program indicator

run