Instruction manual

5.6 Connecting to a CBM-20A or CBM-20Alite System Controller
5-75
RF-20A/20Axs
5
5.6 Connecting to a CBM-20A or
CBM-20Alite System Controller
5.6.1 Setting the Instrument
To operate this instrument with a CBM-20A or CBM-20Alite system controller, make the following settings.
5.6.2 Basic Parameters
The following operations and settings are possible from a CBM-20A/20Alite. For details, refer to the
CBM-20A/20Alite instruction manual.
• Wavelength setting
• Selection of single wavelength mode and dual wavelength mode
• Lamp ON/OFF status
• Gain setting
• Sensitivity setting
• Analog output connector setting
• Response setting
• ON/OFF status of flow cell temperature adjustment, temperature indication (RF-20Axs only)
• Time program creation
Setting Screen Set Value Page
LOCAL 0: Remote ^ "Setting the Local Mode [LOCAL]" P.5-29
ADRS Remote control address ^ "Setting a Remote Control Address [LINK ADRS]" P.5-29
OP MODE 0: 20A ^ "Selecting the Operation Mode [OP MODE]" P.5-46